Article Per Year (5 Year)
p-Index From 2021 - 2026
0.562
P-Index
This Author published in this journals
All Journal International Journal of Electrical and Computer Engineering International Journal of Power Electronics and Drive Systems (IJPEDS)
J. S. Norbakyah
Universiti Malaysia Terengganu
Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering

Published : 4 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : International Journal of Electrical and Computer Engineering

 1 
myBas driving cycle for Kuala Terengganu city J. S. Norbakyah; M. I. Nordiyana; I. N. Anida; A. F. Ayob; A. R. Salisa
International Journal of Electrical and Computer Engineering (IJECE) Vol 11, No 3: June 2021
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v11i3.pp2054-2061

Abstract

Driving cycles are series of data points that represent vehicle speed versus time sequenced profile developed for specific road, route, city or certain location. It is widely utilized in the application of vehicle manufacturers, environmentalists and traffic engineers. Since the vehicles are one of the higher air pollution sources, driving cycle is needed to evaluate the fuel consumption and exhaust emissions. The main objectives in this study are to develop and characterize the driving cycle for myBAS in Kuala Terengganu city using established k-means clustering method and to analyse the fuel consumption and emissions using advanced vehicle simulator (ADVISOR). Operation of myBAS offers 7 trunk routes and one feeder route. The research covered on two operation routes of myBAS which is Kuala Terengganu city-feeder and from Kuala Terengganu to Jeti Merang where the speed-time data is collected using on-board measurement method. In general, driving cycle is made up of a few micro-trips, defined as the trip made between two idling periods. These micro-trips cluster by using the k-means clustering method and matrix laboratory software (MATLAB) is used in developing myBAS driving cycle. Typically, developing the driving cycle based on the real-world in resulting improved the fuel economy and emissions of myBAS.
A Study on PHERB Powertrain Modeling and Analysis J. S. Norbakyah; A. R. Salisa
International Journal of Electrical and Computer Engineering (IJECE) Vol 8, No 3: June 2018
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (810.61 KB) | DOI: 10.11591/ijece.v8i3.pp1822-1829

Abstract

A study on plug-in hybrid electric recreational boat (PHERB) powertrain with a special energy management strategy modeling and analysis was presented in this paper. Firstly, the boat components are sized to meet the expected power and energy requirements through a power flow analysis. Then, the model is tested numerically in the MATLAB/SIMULINK environment using the existing driving cycle. The accuracy of the model is verified by a comparison of the component between the simulation results from PHERB and advanced vehicle simulator (ADVISOR) software. The simulation results of component, fuel economy and emission of PHERB and hybrid electric vehicle models in ADVISOR are compared.
Co-Authors A. F. Ayob A. R. Salisa I. N. Anida M. I. Nordiyana S. K. Arun