Garuda - Garba Rujukan Digital

Abbas Haghollahi

Shahid Rajaee Teacher Training University, Tehran

Author-ID : 3899623

Civil Engineering, Building, Construction & Architecture

Published : 2 Documents Claim Missing Document

Claim Missing Document

Articles

Title

1

Cyclic Behavior of Bolted Extended End-Plate Moment Connections with Different Sizes of End Plate and Bolt Stiffened by a Rib Plate Abbas Haghollahi; Reza Jannesar
Civil Engineering Journal Vol 4, No 1 (2018): January
Publisher : Salehan Institute of Higher Education

This paper presents a numerical study on the behavior of prequalified Bolted Extended End Plate (BEEP) moment connections when are affected by cyclic loading. Specimens were six four-bolt extended end-plate connections consist of H-shaped columns and I-shaped beams with different geometry as well as different end-plate size and bolt diameter; three of them were stiffened by a triangular rib plate welded to the top and bottom of the beam flanges, and others remained unstiffened. They were modeled in ABAQUS software and their cyclic behavior was evaluated using finite element analysis. Responses of specimens were examined by presenting their equivalent plastic strain, stress distribution, and moment-rotation hysteretic curves. Results revealed that with the increase of beam height and inertia moment in equal story drift rotations, the reduction of connection strength occurred earlier due to the occurrence of local buckling in the beam web and flange after subjecting to cyclic loading. By comparing moment-rotation hysteretic responses of specimens, it was found out that in unstiffened BEEP connections with thinner end-plate, the use of single vertical rib stiffener can slightly improve their cyclic behavior, but in connections with thicker end plate, it showed no considerable effect. It was concluded that the BEEP connections whose dimensions are not based on the tenth code of the Iranian national building regulations, cannot satisfy the criteria of AISC seismic provisions for both special and intermediate steel moment frames, although they experienced no local beam web and flange buckling.

Cyclic Behavior of Steel Beam-to-Column Moment Connections Using Different Sizes of Flange Plates and Reinforced by a Single Rib Plate Abbas Haghollahi; Hassan Ahmadi
Civil Engineering Journal Vol 4, No 1 (2018): January
Publisher : Salehan Institute of Higher Education

This paper presents a numerical study on the behavior of connection between steel I-beam and H-column when are affected by cyclic loading. The connection used the flange plates to connect the beam flanges to the column flange. They were welded to the top and bottom flange plates and created a welded flange plate (WFP) connection. Specimens were six models of WFP connections with different beam geometry and flange plate sizes which were modeled and their cyclic behavior were investigated using finite element analysis in ABAQUS program. Three of them were reinforced by a vertical triangular top and bottom rib plates, and others remained unreinforced. The results showed that reinforcement with a vertical triangular rib plate attached to the top and bottom flange plates can improve cyclic behavior of WFP connections. By using a rib plate, the equivalent plastic strain was increased and showed better plastic hinge formation compared to those with no vertical rib plate. Those models with IPB beam sections had the best cyclic behavior compared to those with IPE beam sections and satisfied the acceptance criteria of AISC seismic provisions for intermediate and special moment frames. We concluded that those WFP connections which did not satisfy the criteria of AISC seismic provisions for special moment frames, can be upgraded by a vertical triangular rib plate in order to be used in special moment frames.

Title Search

Found 2 Documents Search Journal : Civil Engineering Journal

Abstract

Abstract

Title

Found 2 Documents
Search
Journal : Civil Engineering Journal