Article Per Year (5 Year)
p-Index From 2021 - 2026
0.408
P-Index
This Author published in this journals
All Journal International Journal of Robotics and Control Systems
Norhaslinda Kamarudzaman
Sultan Ahmad Shah Medical Centre
Control & Systems Engineering Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : international journal of robotics and control systems

 1 
Soft Pneumatic Exoskeleton for Wrist and Thumb Rehabilitation Sa’aadat Syafeeq Lone; Norsinnira Zainul Azlan; Norhaslinda Kamarudzaman
International Journal of Robotics and Control Systems Vol 1, No 4 (2021)
Publisher : Association for Scientific Computing Electronics and Engineering (ASCEE)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31763/ijrcs.v1i4.447

Abstract

A huge population of the world is suffering from various kinds of disabilities that make basic daily activities to be challenging. The use of robotics for limb rehabilitation can assist patients to recover faster and reduce therapist to patient ratio. However, the main problems with current rehabilitation robotics are the devices are bulky, complicated, and expensive. The utilization of pneumatic artificial muscles in a rehabilitation system can reduce the design complexity, thus, making the whole system light and compact. This paper presents the development of a new 2 degree of freedom (DOF) wrist motion and thumb motion exoskeleton. A light-weight 3D printed Acrylonitrile Butadiene Styrene (ABS) material is used to fabricate the exoskeleton. The system is controlled by an Arduino Uno microcontroller board that activates the relay to open and close the solenoid valve to actuate the wrist. It allows the air to flow into and out of the pneumatic artificial muscles (PAM) based on the feedback from the sliding potentiometer. The mathematical model of the exoskeleton has been formulated using the Lagrange formula. A Proportional Integral Derivative (PID) controller has been implemented to drive the wrist extension-flexion motion in achieving the desired set-points during the exercise. The results show that the exoskeleton has successfully realized the wrist and thumb movements as desired. The wrist joint tracked the desired position with a maximum steady-state error of 10% for 101.45ᵒ the set point.
Continuous Passive Motion Machine for Elbow Rehabilitation Hamzah Hussein Mohammed Al-Almoodi; Norsinnira Zainul Azlan; Ifrah Shahdad; Norhaslinda Kamarudzaman
International Journal of Robotics and Control Systems Vol 1, No 3 (2021)
Publisher : Association for Scientific Computing Electronics and Engineering (ASCEE)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31763/ijrcs.v1i3.446

Abstract

Continuous Passive Machines (CPM) facilitate patients in eliminating joint stiffness after surgery and lead to a faster and more efficient recovery. However, many previous CPM machined are mechanically complicated, expensive, and lack a user interface. This paper presents a new CPM machine for elbow flexion-extension and forearm pronation-supination. The machine is simple, low-cost, and equipped with Graphical User Interface (GUI). Its mechanism is designed so that it can be used on the left or right arms interchangeably. It is developed using aluminum, perspex, and steel rods. The electrical part of the machine consists of Arduino Uno to drive the motors and a potentiometer to measure the patients’ Range of Motion (ROM). The GUI for setting the exercise parameters and monitoring the patients’ progress has been developed using MATLAB software. The experimental results show that the machine has successfully provided the repetitive desired motions. The machine realizes elbow flexion-extension and forearm pronation-supination movements with 0ᵒ-135ᵒ and 0ᵒ-90ᵒ ranges of motion (ROM), respectively. The machine is also capable of increasing the elbow joint’s ROM by 5ᵒ increments for the therapy. The results show that the machine has the potential to be used in hospitals and rehabilitation centers.
Co-Authors Hamzah Hussein Mohammed Al-Almoodi Ifrah Shahdad Norsinnira Zainul Azlan Sa’aadat Syafeeq Lone