Article Per Year (5 Year)
p-Index From 2021 - 2026
0.23
P-Index
This Author published in this journals
All Journal International Journal of Robotics and Control Systems
Voitech Stankevic
Vilnius Gediminas Technical University Faculty of Electronics
Control & Systems Engineering Electrical & Electronics Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search
Journal : International Journal of Robotics and Control Systems

 1 
A Simple Method for Stator Inductance and Resistance Estimation for PMSM at Standstill Justas Dilys; Voitech Stankevic
International Journal of Robotics and Control Systems Vol 2, No 3 (2022)
Publisher : Association for Scientific Computing Electronics and Engineering (ASCEE)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31763/ijrcs.v2i3.741

Abstract

An accurate stator resistance and inductance are necessary for high-performance permanent magnet synchronous motor (PMSM) control. The stator resistance and inductance can be estimated during motor standstill operation. This study proposes a standstill estimation method for the determination of dq-axis inductances and resistance of a PMSM drive system fed by a conventional voltage source inverter (VSI). The proposed method estimates both inductance and the rotor's position using the same algorithm, and knowledge of its initial position is not required. The d- and q-axis inductances were estimated by applying three short-time voltage pulses and measuring phase current peak values. The stator's resistance is estimated by monitoring the exponential decay process of the direct axis current. The method was verified by simulation and experiments conducted on two different PM synchronous motors. A good agreement of simulation and experimental results was obtained. Moreover, the proposed method is relatively simple and can identify stator resistance and inductance at any motor load condition. Compared to the existing parameter estimation strategies, the proposed estimation scheme has a relatively faster estimation time. Additionally, it is shown that the method accounts for the dead-time effect as well.
Co-Authors Justas Dilys