<![CDATA[As fracturing materials, fracturing fluid and proppant are two very important parameters in doing hydraulic fracturing design. The combination of fractuirng fluid and proppant selection is the main focus and determinant of success in the hydraulic fracturing process. The high viscosity of the fracturing fluid will make it easier for the proppant to enter to fill the fractured parts, so that the conductivity of the fractured well will be better and can increase the folds of increase (FOI) compared to fracturing fluid with lower viscosity (Economides, 2000). This research was conducted by using the sensitivity test method on the selection of fracturing fluid combinations carried out at the TX-01 well with various sizes of proppants (namely; 12/18, 16/20, and 20/40 mesh) with the proppant selected being ceramic proppant type carbolite performed using the FracCADE simulator. Fracturing fluid was selected based on its viscosity, namely YF240OD and PrimeFRAC20 fluids with viscosity value of 4.123 cp and 171.1 cp, with a fixed pump rate of 14 bpm. The results showed that the combination of high-viscosity fluids (PrimeFRAC20) and 16/20 mesh proppant size resulted in a greater incremental fold (FOI) between the choice of another combination fracturing fluids and proppant sizes, namely 6.25.]]>
Copyrights © 2020
