Journal of Engineering and Technological Sciences
Vol. 52 No. 3 (2020)

Microplastics Abundance and Uptake by Meretrix lyrata (Hard Clam) in Mangrove Forest

Fauziah binti Shahul Hamid (Center for Research in Waste Management, Faculty of Science, University of Malaya, 50603 Kuala Lumpur,)
Wang Jia (Institute of Biological Sciences, Faculty of Science, University of Malaya, 50603 Kuala Lumpur,)
Rozainah Mohamad Zakaria (Institute of Biological Sciences, University of Malaya, Kuala Lumpur, 50603)



Article Info

Publish Date
25 Jun 2020

Abstract

The aim of this study was to determine the abundance and distribution of microplastics in a mangrove ecosystem, while investigating its uptake by Meretrix lyrata. Microplastics were extracted from 10 L of mangrove sediment using a floatation method. Soft tissues of M. lyrata were digested and the microplastics were filtered and observed under a light microscope. Microplastics ranging from 21 µm to 100 µm were the most abundant in the mangrove layers at 936 ± 34 particles/kg (dry sediment) to 1,227 ± 55 particles/kg (dry sediment) (27.19% to 31.16% of the total quantity of recovered microplastics). The most abundant microplastics, with size from 5 µm to 1000 µm, were found in the deepest layer. M. lyrata accumulation of microplastics averaged at 0.35 ± 0.08 particles/g tissue and 0.23 ± 0.07 particles/g tissue (wet weight) before and after three-day depuration, respectively. Microplastics with size from 5 to 20 µm were the most commonly uptaken by the clams, averaging at 58% to 72% for pre-depuration and post-depuration, respectively. This study revealed that the most predominant size of microplastics in the sediment was 5 µm to 20 µm, which concurs with the results of the microplastics most commonly accumulated by M. lyrata. It is believed that microplastics accumulation in mangrove areas increases over time. On the other hand, the uptake rate of microplastics by Meretrix lyrata decreases over time, flushing microplastics from its system more frequently.

Copyrights © 2020






Journal Info

Abbrev

JETS

Publisher

Subject

Engineering

Description

Journal of Engineering and Technological Sciences welcomes full research articles in the area of Engineering Sciences from the following subject areas: Aerospace Engineering, Biotechnology, Chemical Engineering, Civil Engineering, Electrical Engineering, Engineering Physics, Environmental ...