<![CDATA[Arcing is one of the causes of fire disasters that occur quite a lot in the world. The danger of arcing causes enormous losses. The fault current caused by arcing usually occurs in a very short duration, so that safety equipment such as Miniature Circuit Breaker (MCB) and Fuse cannot detect the disturbance. If arcing takes place continuously, there will be heat that can damage the equipment and cause a fire. In this study, an evaluation of the use of mother wavelets in the Discrete Wavelet Transform (DWT) method on low voltage detection equipment will be carried out. DWT is a mathematical function that is the most successful in the field of signal processing. Signal processing using the DWT method will be analyzed and compared its performance with mother wavelets Daubechies-1, Daubechies-4, Coiflet-4, and Symlet-4. Then applied to low voltage arcing detection equipment. From the results of testing and analysis obtained the mother wavelet Daubechies-4 produces a high level of accuracy and sensitivity. Mother wavelet Coiflet-4 and Symlet-4 produce the lowest level of accuracy at 400W and 700W load. Meanwhile, on the mother wavelet Daubechies-1, the normal signal amplitude value is close to the arcing signal amplitude value, so it will be difficult to determine the threshold value. In this study, the results obtained are arcing detection equipment using the mother wavelet Daubechies-4 method can detect arcing disturbances very well and produces a high level of accuracy and sensitivity compared to the mother wavelet Daubechies-1, Coiflet-4 , and Symlet-4.]]>
Copyrights © 2023
