Jurnal Teknik Industri : Jurnal Hasil Penelitian dan Karya Ilmiah dalam Bidang Teknik Industri
Vol 12, No 1 (2026): Juni 2026

Ergonomic Analysis and Redesign of Bus Handgrips Using Rapid Upper Limb Assessment (RULA) and Posture Evaluation Index (PEI)

Dewi, Veronika Chintia (Unknown)
Rifano, Rifano (Unknown)
Gunawan, Gunawan (Unknown)
Marwanto, Riza Phahlevi (Unknown)



Article Info

Publish Date
27 Apr 2026

Abstract

This study aims to analyze and improve the ergonomic performance of bus handgrips on Metro Jabar Trans using an integrated approach combining Rapid Upper Limb Assessment (RULA) and Posture Evaluation Index (PEI). The research employed a quantitative method involving 30 respondents, with data collected through observation, interviews, joint angle measurements, and anthropometric analysis. A virtual simulation was developed using Jack 8.4 software to evaluate ergonomic conditions based on RULA, Lower Back Analysis (LBA), and Ovako Working Posture Analysis System (OWAS), which were then integrated into the PEI metric. The results indicate that the existing handgrip design produces RULA scores predominantly at levels 5–6, reflecting moderate ergonomic risk, with PEI values ranging from 1.358 to 1.875, indicating suboptimal conditions. A redesigned handgrip was developed by optimizing key dimensions, including width, diameter, and finger clearance, based on anthropometric data. Simulation results demonstrate a consistent reduction in ergonomic risk, with PEI values decreasing to a range of 0.925 to 1.221. The reduction in PEI values, ranging from 0.233 to 0.903, confirms improved postural conditions and reduced risk of musculoskeletal disorders. These findings highlight that integrating posture assessment and quantitative ergonomic indices can effectively support the development of safer and more comfortable public transportation facilities.

Copyrights © 2026






Journal Info

Abbrev

jti

Publisher

Subject

Computer Science & IT Decision Sciences, Operations Research & Management Engineering Environmental Science Industrial & Manufacturing Engineering

Description

(ISSN : 2460-898X) JTI merupakan jurnal akademik yang dipublikasikan 2 kali setahun, meliputi bulan Juni dan Desember. Tujuan jurnal ini menyediakan tulisan yang memiliki yang fokus pada bidang Teknik Industri. lebih lanjut jurnal ini dipulikasikan oleh Jurusan Teknik Industri Fakultas Sains dan ...