<![CDATA[Surface roughness is an important quality parameter that affects the performance, durability, and reliability of machined components. Measuring the internal surface roughness of drilled holes using conventional contact-based methods is often difficult. Accessibility of the internal surface is complicated due to the diameter of the drilled hole and the need to interrupt the machining process. To overcome these limitations, the proposed work offers a non-contact method for estimating the surface roughness of drilled Al-7075 using image-based analysis. Drilled surfaces are machined using different speeds and feed rates. High-resolution images of the drilled surface are captured using a custom-built image-capturing setup. Texture and frequency features were extracted using gray-level co-occurrence matrix (GLCM), discrete Fourier transform (DFT), and discrete wavelet transform (DWT) techniques. Surface arithmetic average roughness (Ra) was measured using these extracted features. The estimated roughness parameters were then validated by comparing them against roughness parameters obtained by means of the contact stylus technique. According to the experimental results, the accuracy of the wavelet technique is higher, with mean absolute errors of 0.32 μm compared to those obtained using GLCM and DFT techniques. The findings demonstrate that the proposed image-based framework is a reliable and practical solution for non destructive surface roughness prediction.]]>
Copyrights © 2026
