The development of regenerable heterogeneous catalysts for sustainable biodiesel production remains a major challenge, particularly for continuous-flow systems. This study aimed to develop a functionalized methacrylate-based monolithic polymer as a catalytic microreactor for the continuous transesterification of palm oil. The novelty of this work lies in (i) the use of diethylamine (DEA) as an amination agent for poly(glycidyl methacrylate-co-ethylene glycol dimethacrylate) (PGMEGD) monoliths, (ii) the systematic optimization of the alkalization process to produce an anion-exchange resin, and (iii) the demonstration of catalyst regeneration through an effective sequential washing procedure. PGMEGD monoliths were synthesized in situ using a ternary porogenic system consisting of 1-propanol, 1,4-butanediol, and water, followed by functionalization with DEA at concentrations ranging from 5 to 25% and subsequent alkalization with NaOH. FTIR and SEM analyses confirmed successful chemical modification while preserving the interconnected three-dimensional porous structure of the monolith. The highest amine density of 3.43 mmol g−1 was obtained at a DEA concentration of 20%, whereas an optimum OH− exchange capacity of 3.28 mmol g−1, corresponding to 96% of the amine density, was achieved after alkalization with 1.0 M NaOH. In the continuous transesterification of palm oil with methanol, the catalyst achieved an optimum biodiesel yield of 86.28% at a methanol-to-oil molar ratio of 9:1 and a flow rate of 0.05 mL min−1. The catalyst maintained a biodiesel yield above 80% for four consecutive cycles, while regeneration using sequential citric acid-NaOH-ethanol washing restored more than 99% of its catalytic activity and exhibited a consistent recovery pattern over two regeneration cycles. These findings demonstrate that the PGMEGD-NH2-OH monolithic resin is a promising catalytic microreactor for sustainable biodiesel production under continuous-flow conditions.
Copyrights © 2026