Jurnal Ilmu Fisika
Vol 19 No 1 (2027): March 2027 (Forthcoming Issue)

Effects of Layer Repetition and Cu Spacer Thickness on the Magnetoimpedance of Electrodeposited Permalloy Multilayers at 100 kHz and Its Application as a Magnetic Nanoparticle Sensor

Artono Dwijo Sutomo (Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Sebelas Maret, Surakarta 57126)
Febriani Wulandaria (Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Sebelas Maret, Surakarta 57126)
Pratiwi Kusumawardhani (Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Sebelas Maret, Surakarta 57126)
Riyatun Riyatun (Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Sebelas Maret, Surakarta 57126)
Nurdiyantoro Putra Prasetya (Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Tanjungpura, Pontianak 78124)
Ismail Ismail (Indonesian Polytechnic of Nuclear Technology, National Research and Innovation Agency, Yogyakarta 55281)
Budi Purnama (Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Sebelas Maret, Surakarta 57126)



Article Info

Publish Date
28 Oct 2026

Abstract

Optimizing multilayer structures is essential for improving magnetoimpedance (MI) responses in low-frequency magnetic sensing applications. This study investigates the effects of layer repetition number (N) and Cu spacer thickness (x) on the magnetoimpedance (MI) response of [NiFe(600 nm)/Cu(x)/NiFe(600 nm)]N/Cu(200 nm)/[NiFe(600 nm)/Cu(x)/NiFe(600 nm)]N multilayer structures electrodeposited onto Cu printed circuit board substrates with meander patterns. The MI response was systematically evaluated at an operating frequency of 100 kHz to determine the optimal multilayer configuration. The results reveal that both layer repetition and Cu spacer thickness significantly influence the MI ratio. The highest MI ratio of 2.07% was achieved at N = 3 and x = 100 nm, suggesting an optimal balance between magnetic permeability and electrical conductivity. The sensing capability of the optimized multilayer structure was further evaluated using cobalt ferrite nanoparticles. Changes in the MI ratio of 0.32 and 0.64 were observed for nanoparticle masses of 0.1 and 0.3 g, respectively, indicating a mass-dependent sensor response. These findings demonstrate the potential of electrodeposited NiFe/Cu multilayer structures as low-frequency magnetoimpedance sensing platforms for magnetic nanoparticle detection.

Copyrights © 2027






Journal Info

Abbrev

jif

Publisher

Subject

Astronomy Earth & Planetary Sciences Materials Science & Nanotechnology Physics

Description

Jurnal Ilmu Fisika (JIF) is a peer-reviewed open access journal on interdisciplinary studies of physics, and is published twice a year (March and September) by Department of Physics, Andalas University ...