Journal of Chemical Engineering Research Progress
2027: JCERP, Volume 4 Issue 1 Year 2027 (June) (Issue in Progress)

Experimental Investigation of Joule-Thomson Cooling Induced by Welded Joint Geometry in Natural Gas Pipelines

Romokere Isotuk Uzono (Department of Chemical Engineering, Akwa Ibom State University, Uyo)



Article Info

Publish Date
30 Jun 2027

Abstract

The Joule–Thomson (JT) effect is well characterized at engineered throttling devices such as valves, regulators, and leak orifices, but its occurrence at internal weld-joint geometry, an unintentional, workmanship-tolerance-scale feature present at every girth weld, has not previously been established experimentally; existing JT-cooling studies assume an intentional, externally specified throttling geometry, while weld-integrity studies address the erosion, corrosion, and stress consequences of internal weld irregularities without examining their thermal effect. This study addresses that gap by providing controlled experimental evidence of weld-induced JT cooling as a distinct micro-throttling mechanism. The objective was to determine whether internal weld-joint geometry (weld reinforcement and hi-lo misalignment) constitutes a measurable, thermodynamically consistent JT throttling mechanism under representative natural gas transmission conditions. A natural gas pipeline test section incorporating a smooth-pipe baseline and four internal weld geometries (low, medium, and high reinforcement, and hi-lo misalignment) was tested at upstream pressures of 40–70 bar and flow velocities of 5–15 m/s, with the measured response validated against Peng-Robinson-based isenthalpic predictions (ΔT = μJTΔPw) and independent CFD simulation. The CFD simulation reproduced the experimental pressure loss to within an average of 3.5%. Weld-induced pressure loss and the corresponding corrected temperature response increased systematically with geometric severity and flow velocity, reaching a maximum additional pressure loss of 0.199 bar and a maximum corrected temperature reduction of 0.0404 K for the hi-lo geometry at 60 bar and 15 m/s; flow velocity accounted for 55.96% of the variance in the response, followed by weld geometry (26.62%) and their interaction (13.84%), and a regression model linking temperature response to weld severity, velocity, and pressure achieved R² = 0.9642. These results confirm that internal weld geometry constitutes a genuine, thermodynamically consistent local JT throttling mechanism, one that is two to three orders of magnitude smaller than the cooling associated with engineered throttling devices and unlikely to present a significant hydrate, embrittlement, or corrosion hazard at an isolated girth weld. Copyright © 2027 by Authors, Published by Universitas Diponegoro and BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).

Copyrights © 2027






Journal Info

Abbrev

jcerp

Publisher

Subject

Chemical Engineering, Chemistry & Bioengineering Energy Engineering Materials Science & Nanotechnology

Description

The Journal of Chemical Engineering Research Progress (e-ISSN: 3032-7059; Short Abbreviation Title: J. Chem. Eng. Res. Prog.) is an international research journal and invites contributions of original and novel fundamental research. The JCERP journal aims to provide an international forum for the ...