Unmanned Aerial Vehicles (UAVs) increasingly require lightweight structures, complex geometries, and high functional efficiency, while conventional manufacturing is constrained by geometric limitations, lengthy assembly, and high tooling costs. Additive Manufacturing (AM) offers an alternative through layer-by-layer fabrication, design flexibility, and reduced material waste. This review examines the role of AM in UAV fabrication by comparing five principal AM routes: Fused Deposition Modeling (FDM), Selective Laser Sintering (SLS), Stereolithography (SLA), Selective Laser Melting/Laser Powder Bed Fusion (SLM/LPBF), and Directed Energy Deposition (DED). The review evaluates the relationships among manufacturing process, material system, mechanical performance, and UAV component requirements, including lightweight design, geometric complexity, rapid prototyping, and low-volume production. The findings indicate that FDM with continuous carbon fiber reinforcement is well suited to lightweight structural frames and landing gear, while SLS using PA12 is advantageous for geometrically complex polymer components. SLA is suitable for precision mechanisms, whereas SLM/LPBF using titanium alloys is more appropriate for high-strength brackets and load-bearing components. DED is mainly applicable to repair and large-scale metallic fabrication. However, limitations including anisotropy, process sensitivity, dimensional variability, and limited operational validation remain important challenges. Overall, no single AM process satisfies all UAV requirements. Process selection should therefore consider component function, material behavior, mechanical loading, and service conditions. By mapping these interdependencies, this review provides a structured basis for evidence-based AM process selection and highlights future research directions for reliable UAV development.
Copyrights © 2026