Batik wastewater contains synthetic dyes and chemicals that may endanger workers and nearby communities, so continuous monitoring is needed. This study developed and evaluated a prototype Internet of Things (IoT) based environmental health monitoring information system for batik wastewater, using an ESP32 microcontroller, pH and Total Dissolved Solids (TDS) sensors, ThingSpeak, and a local web dashboard. A prototype development and descriptive functional evaluation design was used. One batik wastewater sample was observed for about 30 minutes, producing 100 pH entries and 100 TDS entries, together with device operational logs and interface documentation. The sensors were not calibrated, so the readings describe variation only: pH ranged from 7.59 to 11.61 (mean 8.77) and TDS from 0 to 695.36 ppm (median 652.28 ppm). The log contained 228 identifiable status messages, of which 38 (16.7%) indicated successful transmission to ThingSpeak and 190 indicated failure; these are log messages, not the 100 data entries, so the online record was incomplete. Code -401 accounted for 186 failures, and the upload interval, which was probably shorter than the 15 second limit of free ThingSpeak accounts, is the most likely cause, although this was not tested. The prototype fulfilled basic data acquisition and visualization. Longer upload intervals or bulk updates, local buffering with resending, validation rules, and calibration against reference instruments are needed before the data can support environmental health information systems and early warning.
Copyrights © 2026