Teknomekanik
Vol. 9 No. 3 (2026): Regular Issue

Combustion and emission responses of methanol-enriched catalytic plastic waste pyrolysis oil in a stationary otto engine

Enzo Wiranta Battra Siahaan (Department of Mechanical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Indonesia)
Tulus Burhanuudin Sitorus (Department of Mechanical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Indonesia)
Himsar Ambarita (Department of Mechanical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Indonesia)
Taufiq Bin Nur (Department of Mechanical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Indonesia)
Ilmi Abdullah (Department of Mechanical Engineering, Faculty of Engineering, Universitas Sumatera Utara, Indonesia)
Janter P Simanjuntak (Department of Mechanical Engineering, Faculty of Engineering, Universitas Negeri Medan, Indonesia)



Article Info

Publish Date
30 Oct 2026

Abstract

Plastic waste pyrolysis oil (PWPO) offers a waste-to-energy pathway; however, its use in small spark-ignition engines is constrained by fuel-property variability, mixture preparation, and combustion phasing. This study integrated evidence on fuel properties, crank-angle-resolved combustion, indicated performance, cyclic variability, and emissions for PWPO produced using a silica-alumina catalyst containing 0, 5, 10, and 15 vol.% methanol in a 163 cm³ single-cylinder stationary Otto engine at engine speeds of 1,500–4,000 rpm. A 4 × 6 operating matrix was used to compare pressure-volume behavior, pressure-crank-angle development, apparent heat-release rate (HRR), CA10/CA50/CA90 phasing, net indicated mean effective pressure (IMEPₙ), COVIMEP, and gaseous emissions. The response to methanol was distinctly non-monotonic. M10 generally produced the highest IMEPₙ, whereas M5 yielded the lowest speed-averaged CO (3.87 vol.%, 16.9% below PWPO) and M10 yielded the lowest speed-averaged HC (411.7 ppm, 28.1% below PWPO); CO emissions from M10 were 14.2% lower than those from PWPO. Re-examination of the archived burn-phasing data showed that the M10 CA10-CA90 interval was approximately 2.8-5.6% longer than that of PWPO despite earlier CA90, while M10 COVIMEP remained approximately 16-25% under no-load conditions. The evidence therefore supports a trade-off between fuel composition and engine responses rather than a concentration-proportional benefit or statistically validated optimum: moderate methanol reformulation improved pressure development and incomplete-combustion emissions, but did not eliminate cyclic instability.

Copyrights © 2026






Journal Info

Abbrev

teknomekanik

Publisher

Subject

Mechanical Engineering

Description

Teknomekanik is an international journal that publishes peer-reviewed research in engineering fields (miscellaneous) to the world community. Paper written collaboratively by researchers from various countries is encouraged. It aims to promote academic exchange and increase collaboration among ...