cover
Contact Name
Dayat Kurniawan
Contact Email
Dayat Kurniawan
Phone
-
Journal Mail Official
redaksi@jurnalet.com
Editorial Address
-
Location
Kota adm. jakarta selatan,
Dki jakarta
INDONESIA
Jurnal Elektronika dan Telekomunikasi
ISSN : 14118289     EISSN : 25279955     DOI : -
Core Subject : Engineering,
Jurnal Elektronika dan Telekomunikasi (JET) is an open access, a peer-reviewed journal published by Research Center for Electronics and Telecommunication - Indonesian Institute of Sciences. We publish original research papers, review articles and case studies on the latest research and developments in the field of electronics, telecommunications, and microelectronics engineering. JET is published twice a year and uses double-blind peer review. It was first published in 2001.
Arjuna Subject : -
Articles 18 Documents
Search results for , issue "Vol 18, No 2 (2018)" : 18 Documents clear
Fractional-N PLL Synthesizer for FMCW Signal Generator with Dual-Mode Modulation Pattern R. Indrawijaya; R. Sariningrum; B. Edi Sukoco; D. Muliawandana
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14203/jet.v18.46-52

Abstract

Radar signal generator is a critical component in radar system as it determines the best achievable resolution. Single chip Fractional-N PLL synthesizer with built-in VCO and sweep modulator become more popular as Frequency Modulated Continuous Wave (FMCW) signal generator due to the simplicity and overall cost reduction. This paper presents a realization process and experimental result of dual-mode modulation pattern FMCW signal generator using HMC769LP6CE PLL. The PLL is controlled by ATMega328 microcontroller and Altera EPM240T100C5 CPLD to operate in two difference mode: 1-way sweep mode and 2-way sweep mode. The PLL is programmed with four different sweep bandwidth from 6.75–54 MHz for different range and resolution radar purpose. The performance of FMCW signal generator is measured using the output of passband signal spectrum. The experimental results indicate that the PLL-VCO with 2-way sweep mode has clearer frequency passband compared to 1-way sweep mode.
Preface Vol. 18 No. 2 Tajul Miftahushudur
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Performance Evaluation of Distribution Node in Case of LEACH Implementation on Wireless Sensor Network Bagas Mardiasyah Prakoso; Ahmad Zainudin; Prima Kristalina; Rizqi Fauzil Azhar
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14203/jet.v18.67-74

Abstract

Wireless sensor networks consisting of sensor nodes can be used as an effective tool for collecting data in various situations. Nodes are usually placed randomly in an area to perform sensing and monitor various parameters related to environmental conditions in various locations. One of the major problems in wireless sensor networks is developing energy-efficient routing protocols that have a significant impact on the overall life of sensor networks so it is important to make energy savings in these limited energy sources to extend network life. This paper proposes a hardware design and Low-Energy Adaptive Clustering Hierarchy (LEACH) routing protocol configuration for power saving by utilizing cluster head selection mechanism. The cluster head selection process is performed periodically based on LEACH algorithm enables the node to have the best lifetime responsible for communication between the nodes and the server as well as the effort to save energy consumption of limited energy sources to extend network life. So that makes the process of sending information more effective and optimal. The system has been able to display data information along with the position of nodes in the web server with an average of 42 seconds of computing time in a rotation of the system so that it can be done 85 times in 1 hour. The system is able to provide real-time information with a throughput of more than 1.052 Kbps and packet loss of no more than 6.7%. In addition, energy savings can up to 6.5% of the existing energy in a lithium battery.
Appendix Vol. 18 No. 2 Tajul Miftahushudur
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Rotational Speed Control of Brushless Dc Motor Using Genetic Algorithm Optimized PD Controller Rizqi Andry Ardiansyah; Edwar Yazid
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14203/jet.v18.75-80

Abstract

Controlling the rotational speed of brushless DC (BLDC) motor is an essential task to improve the transient and the steady state performances under loaded condition. Rotational speed control of BLDC motor using genetic algorithm optimized proportional-derivative (PD) controller to form what the so-called the genetic algorithm-PD (GA-PD) controller is proposed in this paper. Control system is realized in a microcontroller namely a 16MHz Atmega2560 with an absolute encoder as a position sensor. The effectiveness of the GA-PD controller is tested under constant and varying step functions with the Ziegler-Nichols-PD (ZN-PD) controller as a benchmark. Experimental results show that the GA-PD controller has slower speed than the ZN-PD controller, but the latter has overshoot and small oscillations during its steady state condition as a consequent of having a fast rise time.
Front Cover Vol. 18 No. 2 Chaeriah Bin Ali Wael
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Effect of Geometrical Structure to the Performance of Monolithic Dye–Sensitized Solar Cells Bayu Aditya Nugraha; Shobih Shobih; Jojo Hidayat; Dahlang Tahir
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14203/jet.v18.53-59

Abstract

Since invented for the first time, researchers in the world were focusing on how to increase the efficiency of dye-sensitized solar cells (DSSC) and reduce of the fabrication cost. Monolithic type of DSSC is one of the best solutions to reduce the fabrication cost due to the elimination of one of transparent conductive oxide (TCO) substrate. In this study, DSSC monolithic was fabricated layer by layer by using screen printing method. There are three layers that printed in each cell namely TiO2, ZrO2, and carbon before being injected with electrolytes. The geometrical structure of DSSC was varied to find the highest performance. From the I-V characteristics and incident photon-to-current efficiency (IPCE) characterization shows the highest efficiency is 0.137% and the highest conversion of photons to current occurs at around 510 nm wavelength, for a structure which has ZrO­2 layer not crosses over the no-FTO area, while TiO2 layer half crosses the no-FTO area, this is most likely caused by the imperfection of the ZrO2layer.
Back Cover Vol. 18 No. 2 Chaeriah Bin Ali Wael
Jurnal Elektronika dan Telekomunikasi Vol 18, No 2 (2018)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Page 2 of 2 | Total Record : 18