Garuda - Garba Rujukan Digital

Article Per Year (5 Year)

All

International Journal of Applied Power Engineering (IJAPE)

IJAPE
Website

Published by Institute of Advanced Engineering and Science

ISSN : 22528792 EISSN : 27222624 DOI : -

Core Subject : Engineering,

Electrical & Electronics Engineering

International Journal of Applied Power Engineering (IJAPE) focuses on the applied works in the areas of power generation, transmission and distribution, sustainable energy, applications of power control in large power systems, etc. The main objective of IJAPE is to bring out the latest practices in research in the above mentioned areas for efficient and cost effective operations of power systems. The journal covers, but not limited to, the following scope: electric power generation, transmission and distribution, energy conversion, electrical machinery, sustainable energy, insulation, solar energy, high-power semiconductors, power quality, power economic, FACTS, renewable energy, electromagnetic compatibility, electrical engineering materials, high voltage insulation technologies, high voltage apparatuses, lightning, protection system, power system analysis, SCADA, and electrical measurements.

Arjuna Subject : -

Articles 5 Documents

Search results for , issue "Vol 6, No 1: April 2017" : 5 Documents clear

Modeling, Analysis and Control of Different DC-DC Converter Topologies for Photovoltaic Emulator Mohammad Tauquir Iqbal; Mohd Tariq
International Journal of Applied Power Engineering (IJAPE) Vol 6, No 1: April 2017
Publisher : Institute of Advanced Engineering and Science

This paper presents the modeling, analysis and control of different DC-DC converter topologies to emulate the photovoltaic (PV) system. A PV emulator is basically a DC-DC converter having same electrical characteristics that of solar PV panel. The emulator helps to achieve real characteristics of PV system in a better way in an environment where using actual PV systems can produce inconsistent results due to variation in weather conditions. The paper describes different types of DC-DC converters like buck, Resonant and Quasi Resonant Converter. The complete system is modelled in MATLAB® Simulink SimPowerSystem software package. The Simulation results obtained from the MATLAB® Simulink SimPowerSystem software package for different topologies under steady and dynamic conditions are analyzed and presented. An evaluation table is also presented at the end of the paper, presenting the effectiveness of each topology.

Small Scale Wind Generation System: Part I – Experimental Verification Of Flux Reversal Generator Block B. Vidhya; K. N. Srinivas
International Journal of Applied Power Engineering (IJAPE) Vol 6, No 1: April 2017
Publisher : Institute of Advanced Engineering and Science

This research work, titled Small Scale Wind Generation System, reported in part I and part II, proposes modeling, analysis and control of a small scale wind energy conversion system employing a direct driven Flux Reversal Generator (FRG) connected to the micro grid through a Quasi-Z-Source Inverter (QZSI). The application of QZSI using FRG to feed micro grid is proposed for the first time in this research work. The QZSI can realize buck/boost, inversion and power conditioning in a single stage with improved reliability. Also it features a wide range of voltage gain which is suitable for applications in wind systems, due to the fact that the wind generator output varies widely with wind velocity. In addition, the modified Space Vector PWM (SVPWM) technique is proposed in this paper to satisfy the shoot-through characteristic of QZSI. This also adds to the contribution of this research work. In this part I of this full research, modelling of the small scale FRG for wind system using Finite Element Analysis (FEA) is presented. The major parameter of FRG viz, voltage, current, torque and power are analyzed, validated and then represented in d-q model. The simulation results are validated with the analytical results. An experimental set-up to run the full procedure reported in this paper. These results form the basis for part II of this research work.

Small Scale Wind Generation System: Part II – A Novel Quasi-Z-Source Inverter and FRG-QZSI-Micro Grid Interface M. Ramkumar; K. N. Srinivas
International Journal of Applied Power Engineering (IJAPE) Vol 6, No 1: April 2017
Publisher : Institute of Advanced Engineering and Science

This paper proposes modelling, analysis and control of a small scale wind energy conversion system employing a direct driven Flux Reversal Generator (FRG) connected to the micro grid through a quasi-Z-source inverter (QZSI). This entire research is made up of two major parts viz., FRG and QZSI. In the part I report of this research work, the role of FRG has been thoroughly modelled and verified. In this part II, the modelling and analysis of QZSI for this purpose is presented. In addition, the modified space vector PWM (SVPWM) technique is proposed in this paper to satisfy the shoot-through characteristic of QZSI, which is a novel. The interface of FRG and QZSI to inject power in to micro grid has been finally presented. The simulation results are validated with the analytical results. Section I discusses the open loop control of QZSI. The mathematical modelling of QZSI for this purpose is given and analytically validated. This flowed by section II in which the proposed SVPWM is presented. The procedure to obtain triggering pulses using this proposed modulation technique is discussed. Section III presents closed loop control strategies for QZSI. Section IV presents the micro gridinte face and power injection.

A New Method of Insulation Wire for Power Transformers Khalaf Y. Al-Zyoud
International Journal of Applied Power Engineering (IJAPE) Vol 6, No 1: April 2017
Publisher : Institute of Advanced Engineering and Science

This task go in order to developing a new way of enameled and polyester foil insulation of conductors used in building transformers thermal of class temperature about (150 ℃), the production technology for two types of enameled and polyester foil-insulation conduction are presented. As will as the physical, mechanical and electrical characteristics of conductors in a normal climate N2, in a tropical climate T2 and after 28 cycle at ( 200 ℃ ) are presented.

Unified Power Quality Conditioner Using Injection Capacitors for Voltage Sag Compensation Madhusmita Patro; Kanhu Charan Bhuyan
International Journal of Applied Power Engineering (IJAPE) Vol 6, No 1: April 2017
Publisher : Institute of Advanced Engineering and Science

Power quality has become an important factor in power systems, for consumer and household appliances. The main causes of poor power quality are har ue of achieving active current distortion compensation, power factor monic currents, poor power factor, supply voltage variations etc. A techniq correction and also mitigating the supply voltage variations at load side is compensated by unique device UPQC presented in this thesis. This concept presents a multi loop based controller to compensate power quality problems through a three phase four wire Unified Power Quality Conditioner (UPQC) under unbalanced and distorted load conditions. Here the UPQC is constituted of two Voltage Source Converters (VSC) connected via power link. The series compensator is connected to the line in series and injects the voltage and thus compensates for voltage issues; whereas the shunt compensator injects current thus compensating for current issues, and is connected in shunt to the line. The voltage injection to the line uses an ijecting transformer. The injection transformer is later replaced with injection capacitors, thus eliminating the drawback of conventional UPQC. In this way a good power quality is maintained

Page 1 of 1 | Total Record : 5

Filter by Year

2017 2017

Filter By Issues

All Issue Vol 14, No 4: December 2025 Vol 14, No 3: September 2025 Vol 14, No 2: June 2025 Vol 14, No 1: March 2025 Vol 13, No 4: December 2024 Vol 13, No 3: September 2024 Vol 13, No 2: June 2024 Vol 13, No 1: March 2024 Vol 12, No 4: December 2023 Vol 12, No 3: September 2023 Vol 12, No 2: June 2023 Vol 12, No 1: March 2023 Vol 11, No 4: December 2022 Vol 11, No 3: September 2022 Vol 11, No 2: June 2022 Vol 11, No 1: March 2022 Vol 10, No 4: December 2021 Vol 10, No 3: September 2021 Vol 10, No 2: June 2021 Vol 10, No 1: March 2021 Vol 9, No 3: December 2020 Vol 9, No 2: August 2020 Vol 9, No 1: April 2020 Vol 8, No 3: December 2019 Vol 8, No 2: August 2019 Vol 8, No 1: April 2019 Vol 7, No 3: December 2018 Vol 7, No 2: August 2018 Vol 7, No 1: April 2018 Vol 6, No 3: December 2017 Vol 6, No 2: August 2017 Vol 6, No 1: April 2017 Vol 5, No 3: December 2016 Vol 5, No 2: August 2016 Vol 5, No 1: April 2016 Vol 4, No 3: December 2015 Vol 4, No 2: August 2015 Vol 4, No 1: April 2015 Vol 3, No 3: December 2014 Vol 3, No 2: August 2014 Vol 3, No 1: April 2014 Vol 2, No 3: December 2013 Vol 2, No 2: August 2013 Vol 2, No 1: April 2013 Vol 1, No 3: December 2012 Vol 1, No 2: August 2012 Vol 1, No 1: April 2012 Vol 10 More Issue

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota yogyakarta,

Daerah istimewa yogyakarta

INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name -

Contact Email -

Phone -

Journal Mail Official -

Editorial Address -

Location Kota yogyakarta, Daerah istimewa yogyakarta INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota yogyakarta,

Daerah istimewa yogyakarta

INDONESIA