I.B. Alit
Universitas Mataram ID Scopus: https://www.scopus.com/authid/detail.uri?authorId=57200120336

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Effect of the number of exhaust fans on a rotary dryer for turmeric drying I.B. Alit; I.G.B Susana; I.G.A.K.C. Adhi; S. Hidayatullah; E. Gunawan
Dinamika Teknik Mesin Vol 16, No 1 (2026): Dinamika Teknik Mesin: Jurnal Keilmuan dan Terapan Teknik Mesin
Publisher : Universitas Mataram

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29303/dtm.v16i1.1137

Abstract

One type of dryer frequently used in agricultural drying is the rotary dryer. When solids are dried in a rotary dryer, a transport phenomenon occurs that includes the simultaneous transfer of mass, heat, and momentum. This study aims to determine the effect of the number of exhaust fans on the drying performance of turmeric using a rotary dryer. The number of exhaust fans used varied from 1, 2, and 3 units. The main parameters observed included the final moisture content, drying rate, and energy efficiency. The results showed that the use of one exhaust fan resulted in the lowest final moisture content compared to other configurations. During the 8-hour drying process, the rotary dryer with one exhaust fan was able to reduce the turmeric moisture content from 89% to 57.8%, with an average drying rate of 0.55 kg/hour. The use of one exhaust fan resulted in an optimal temperature range of 50–60°C. In addition, this configuration also showed relatively high energy efficiency, ranging from 10.8% to 25.5%. Therefore, the use of a single exhaust fan in a rotary dryer is considered the most optimal configuration in balancing the quality of drying results and energy efficiency.
Analysis of thermal performance and collector efficiency of solar distillation system with modified absorber surface shape I.B. Alit; M. Wirawan
Dinamika Teknik Mesin Vol 16, No 2 (2026): Dinamika Teknik Mesin: Jurnal Keilmuan dan Terapan Teknik Mesin
Publisher : Universitas Mataram

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29303/dtm.v16i2.1356

Abstract

Solar distillation is an environmentally friendly technology that is effective for addressing the clean water crisis; however, its performance is often limited by the low heat transfer rate on the absorber plate. This study aims to analyze the effect of variations in absorber geometry (flat plate, and U-corrugated) on the water temperature profile, cumulative freshwater productivity, and collector efficiency in a solar distillation system. Experimental testing was conducted from 10:00 to 14:00. The results indicate that modifying the absorber geometry significantly enhances thermal performance. The U-corrugated absorber recorded the highest water temperature of 59.9 °C at 12:00, coinciding with the peak solar radiation intensity. Furthermore, the U-corrugated absorber produced the highest cumulative freshwater yield, reaching 895 mL at the end of the testing period (14:00), and the flat plate (705 mL). In terms of thermal collector efficiency, the U-corrugated type achieved the highest efficiency of 33.6% at 13:00. The enlarged surface area of the absorber and the enhanced fluid turbulence induced by the U-corrugated geometry were proven to accelerate the evaporation rate. Overall, the utilization of a U-corrugated absorber represents geometric strategy for enhancing heat energy transfer and maximizing the productivity of solar water distillation systems.