Article Per Year (5 Year)
p-Index From 2021 - 2026
0
P-Index
This Author published in this journals
All Journal TEKNIK
Parhimpunan Purba
Unknown Affiliation
Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
TEKNIK – Vol. 29 No. 2 Tahun 2008, ISSN 0852-1697 139 *) Staf Pengajar Jurusan D III Teknik Sipil Fakultas Teknik Undip TEGANGAN SEKUNDER PADA STRUKTUR RANGKA BATANG Parhimpunan Purba
TEKNIK Vol 29, No 2 (2008)
Publisher : Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (153.268 KB) | DOI: 10.14710/teknik.v29i2.1935

Abstract

In our previous analysis of trusses, it was always assumed that the truss members are joined by idealhinges and that loads are applied only at joints. The centroidal axes all of members are stright,coincide with the lines connecting the joint center, and lie in a plane that also contains the lines ofaction of all the loads and reaction. Thus the members of truss are subjected to axial force only, andthese can be determined by static method. A stress analysis base on these assumtion leads to thedetermination of so – called “primary stresses”.In actual cases the joint are usually riveted or welded; and because of this fact the members undergo,not only axial forces, but also bending stresses from secondary moment, cuased by this condition arecalled “secondary stresses”. In discusing secondary stresses we shall consider only trussses in oneplane and assume that this plane represents the plane of symmetri for all members and that externalloads are acting in the same plane. Of these the most important are caused by the fact that the jointare rigid, and hence the members are not free to change their relative directions when the truss isdeformed. This problem can likewise be solved very eficiently by means of moment distibution.From the first analyze result, it was obtained the scondary tension ratio with the primary tension at thepull shaft about 19.20 %. This result is significant that it will increase the existence of primary tension.At the analyze by SAP 2000 is obtained that the end tension much more lower than the scondarytension in the first analyze. This is need to obtain attention at planning trusses.
RANCANG BANGUN KOTAK PENYIMPAN IKAN BERINSULASI UNTUK MEMPERTAHANKAN KUALITAS IKAN DENGAN PROSES PENDINGINAN SERTA APLIKASINYA PADA IKAN TONGKOL (AUXIS THAZARD) Margaretha Tuti Susanti; Parhimpunan Purba
TEKNIK Vol 29, No 2 (2008)
Publisher : Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (169.256 KB) | DOI: 10.14710/teknik.v29i2.1933

Abstract

Fish Cooler Box Have Designed With Measurement 50 X 70 X 40 Cm, with layers box wall and the partfrom out box : fiber glass, strerofoam wood and fiber glass. The boxes will be aplicate for tongkol fish(Auxis thazard) preservation. Variation that done in this research is comparation between ice and fish.topreservation times. Parameter that measured are fish quality like : fat degradation with TMA method,protein degradation with TVB method, rotten with TMAO method, and organoleptic test like : smell,appearence, texture. Result of this research with that parameter tests are : comparation between ice andfish 2:1, but with comparation 1:1 fish quality is still good for consumption
Co-Authors Margaretha Tuti Susanti