Januarti J. Ekaputri
Department of Civil Engineering, Faculty of Civil, Planning and Geo Engineering, Institut Teknologi Sepuluh Nopember, Kampus ITS, Sukolilo, Surabaya 60111

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Experimental Evaluation of Concrete Structural Properties with Recycled Coarse Aggregate and Rice Husk Ash Doha EL-Sayed; Ahmed Youssef; Januarti J. Ekaputri; Tiao Wang; Reda Fadallah
Civil Engineering Journal Vol. 12 No. 8 (2026): August
Publisher : Salehan Institute of Higher Education

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28991/CEJ-2026-012-08-05

Abstract

The present work examines the mechanical and structural performance of concrete in which rice husk ash (RHA) partially replaces cement and recycled concrete coarse aggregate (RCA) serves as an alternative to natural coarse aggregate (NCA). Fifteen concrete mixtures were prepared with RCA replacement levels of 0%, 25%, 50%, 75%, and 100% and RHA contents of 0%, 10%, and 20%. Compressive strength was evaluated at 7, 28, and 91 days, while splitting tensile strength was measured at 28 days. Additionally, the structural response of two reinforced concrete beams was assessed under both flexural and shear loading conditions for a reference beam and a beam produced with 100% RCA and 20% RHA. Results showed that increasing RCA content reduced compressive strength by approximately 2–27% and splitting tensile strength by 14.8–37.2% relative to conventional concrete. The incorporation of RHA at 10% and 20% produced similar trends, with compressive strength reductions of about 15% and 27% at 0% and 100% RCA replacement levels, respectively. Although the beam containing 100% RCA and 20% RHA exhibited lower toughness and ductility than the control beam, both beams achieved comparable ultimate load capacities and showed nearly identical responses under shear loading.
Investigation of Reinforced Concrete Slabs Strengthened with Shear-Connected Mesh Jacketing Omar Magdy; Januarti J. Ekaputri; Mahmoud Hegazy; Ahmed Youssef
Civil Engineering Journal Vol. 12 No. 9 (2026): September
Publisher : Salehan Institute of Higher Education

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28991/CEJ-2026-012-09-020

Abstract

This study investigates the effectiveness of an integrated repair technique for corroded reinforced concrete (RC) slabs using mechanical surface preparation, steel dowels, supplementary reinforcement mesh, and shotcrete jacketing. Six standard-scale RC slab specimens were tested under static two-point loading: one uncorroded control slab (S01); two corroded unrepaired slabs with steel mass losses of 10.6% (S03) and 16.2% (S02); two repaired slabs at the same corrosion levels (S06 and S05); and one uncorroded slab strengthened with compression-zone jacketing (S04). The results showed that corrosion reduced the peak load by about 14% and resulted in losses in stiffness and ductility. In contrast, the proposed repair technique not only restored the original capacity but also increased the peak load by 71–75% compared with the control slab. Although the repaired specimens exhibited higher initial stiffness, they reached their maximum load at smaller deflections, indicating reduced ductility. Compression-zone strengthening improved the peak load by 30% and enhanced post-peak behavior. No interface debonding was observed, demonstrating effective composite action, and confirming the suitability of the proposed system for rehabilitating corrosion-damaged RC slabs.