Putri Nurdiah
Department of Chemistry, Faculty of Mathematics and Natural Sciences,Universitas Sumatera Utara, Medan 20155, Indonesia

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

The Effectiveness of Bioadsorbent from Durian Peel Waste Activated with Phosphoric Acid (H3PO4) in Reducing Iron (Fe) Metal Levels in Dug Well Water Boby Cahyady; Putri Nurdiah
Journal of Chemical Natural Resources Vol. 7 No. 2 (2025): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v7i2.26920

Abstract

The levels of iron (Fe) metal can be reduced by adsorption in water using durian skin waste adsorbent containing cellulose as the basic material for making activated carbon. Durian skin waste is cleaned with running water and then dried. After that, it is carbonized with a furnace at a temperature of 400 ° C for 2 hours and then chemically activated with 10% H3PO4 which is soaked for 24 hours. The activated carbon obtained is characterized using X-Ray Diffraction (XRD) and the parameters observed include water content (%), ash content (%), and iodine absorption (%). The absorption of iron (Fe) metal from dug well water is carried out using the static method at contact time variations of 60, 90, and 120 minutes. The levels of iron (Fe) metal are analyzed by Atomic Absorption Spectrophotometry (AAS). The results showed that the activated carbon produced was predominantly amorphous with a water content of 4.5%; ash content of 7.95%; and an iodine absorption value of 964.44 mg/g. Activated carbon from durian skin waste successfully absorbed Iron (Fe) metal and experienced a decrease with a percentage decrease in Iron (Fe) metal content against the length of contact time, respectively, were 83.55%; 93.88%; and 90% and the optimum contact time occurred at an adsorption time of 90 minutes. The modeling of the kinetics of durian skin activated carbon adsorption on Iron (Fe) Metal follows pseudo second-order modeling.