Sri Wahyu Suciyati
Department of Physics, Faculty of Mathematics and Natural Sciences, University of Lampung, Bandar Lampung 35145

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Design and Development of an IoT-Based Monitoring and Control System for Dual Lithium-Ion Battery Charging Using Photovoltaic Energy Gurum Ahmad Pauzi; Herlambang Sihombing; Junaidi; Sri Wahyu Suciyati
Journal of Energy, Material, and Instrumentation Technology Vol 7 No 3 (2026): Journal of Energy, Material, and Instrumentation Technology
Publisher : Departement of Physics, Faculty of Mathematics and Natural Sciences, University of Lampung

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.23960/jemit.196

Abstract

Despite the growing demand for eco-friendly electric vehicles powered by renewable solar energy, conventional battery management systems do not offer effective remote tracking nor do they efficiently handle charging path switching between dual batteries. To resolve this limitation, an Internet of Things (IoT)-based monitoring and control system was developed for dual Lithium-ion batteries (48 V 20 Ah) powered by a 100 Wp solar panel. The architecture utilizes a NodeMCU ESP32 microcontroller, a ThingSpeak platform, and a Twilio-based WhatsApp Bot for remote execution. Experimental evaluations spanning 390-minute daily cycles demonstrated that measurement errors did not exceed 3.35% (Voltage Sensor I and II achieved 97.53% and 96.65% accuracy, respectively). Furthermore, data transmission on ThingSpeak did not cause operational instability with an average latency of 10.3 seconds, while WhatsApp Bot commands took no longer than 3.72 seconds on average to activate relay responses (2.31–7.40 seconds). During charge–discharge cycles, Battery I gained +4.99 V during charging and lost -5.14 V during discharging, whereas Battery II lost -4.76 V during discharging and gained +5.40 V during charging. Overall, the designed prototype encountered no failures in tracking voltage dynamics or executing automated path switching, confirming its viability for smart renewable energy management.
Implementasi Radio Frequency Energy Harvesting Pada Frekuensi Kerja WiFi 2,4 GHz Untuk Perangkat Bertegangan DC Rendah Ester Novi Andriani; Gurum Ahmad Pauzi; Junaidi; Sri Wahyu Suciyati
Journal of Energy, Material, and Instrumentation Technology Vol 7 No 3 (2026): Journal of Energy, Material, and Instrumentation Technology
Publisher : Departement of Physics, Faculty of Mathematics and Natural Sciences, University of Lampung

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.23960/jemit.201

Abstract

This study presents the design and experimental evaluation of a 2.4 GHz rectenna for radio-frequency (RF) energy harvesting. The system integrates a circular microstrip patch antenna fabricated on an FR-4 epoxy substrate with a three-stage voltage-doubler rectifier employing BAT17 Schottky diodes. Antenna parameters were optimized using ANSYS HFSS, and the selected configuration comprised an 18 mm patch radius, 24 mm feedline length, and 5 mm feedline width. The simulated antenna exhibited a VSWR of 12.7312 and a return loss of -4.0849 dB. The fabricated rectenna was experimentally tested using a Wi-Fi source during morning, afternoon, and evening periods. The maximum measured DC output voltages were 74.69, 56.77, and 80.78 mV, respectively, with the highest output obtained during the evening measurement. The results demonstrate the feasibility of harvesting RF energy from Wi-Fi signals using the proposed rectenna. However, the relatively high VSWR indicates that further impedance-matching optimization is required to improve RF power transfer and overall energy-harvesting performance.