Claim Missing Document
Check
Articles

Found 2 Documents
Search

ANALISIS PENAMBAHAN BAHAN PENGISI PASIR SILIKA PADA BAHAN RESIN EPOKSI SILICONE RUBBER TERHADAP PARAMETER LISTRIK, MEKANIK DAN FISIK UNTUK BAHAN ISOLATOR Savitri, Fanny Rizka; Syakur, Abdul; Hermawan, Hermawan
Transient: Jurnal Ilmiah Teknik Elektro TRANSIENT, VOL. 8, NO. 2, JUNI 2019
Publisher : Universitas Diponegoro

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1039.325 KB) | DOI: 10.14710/transient.8.2.171-180

Abstract

Riset terhadap bahan isolator polimer saat ini masih menjadi sebuah tantangan. Kemampuan isolator polimer yang lebih ringan dan dapat ditambahkan pengisi untuk memperbaiki kekuatan isolator masih menjadi sebuah riset. Kajian terhadap kinerja isolator telah dilakukan sehingga diperoleh komposisi bahan yang ideal sebagai komposisi bahan pembuatan isolator. Penelitian ini merupakan bagian dari kegiatan mencari komposisi bahan pembuatan isolator yang lebih baik dari segi mekanik, elektrik dan fisik. Sampel pengujian menggunakan bahan isolasi resin epoksi yang terbuat dari campuran Diglycidyl Ether of Bisphenol-A (DGEBA) dan Metaphenylene Diamine (MPDA) dengan campuran bahan pengisi silicone rubber dan pasir silika. Bahan pengisi pasir silika divariasi dengan persentase 7,5%, 10%, 12,5%, 15%, 17,5%. Parameter yang dianalisa adalah sudut kontak, nilai arus bocor, tegangan flashover, kekuatan tarik dan nilai kekerasan bahan. Hasil penelitian menunjukkan bahwa penambahan bahan pengisi pasir silika pada bahan isolator resin epoksi silicon rubber untuk memperbaiki kekuatan mekanik bahan isolator. Didapatkan komposisi terbaik untuk bahan isolator dengan  pengisi pasir silika sebesar 10% dengan nilai sudut kontak sebesar 55,85o, nilai arus bocor sebesar 3,35 mA, tegangan flashover sebesar 16,39 kV, kekuatan mekanis sebesar 11,13 Mpa dan kekerasan sebesar 213,6 HV.
Analisis Kualitas Minyak Trafo Menggunakan Data Dissolved Gas Analysis dan Water Content Syakur, Abdul; Savitri, Fanny Rizka
PROtek : Jurnal Ilmiah Teknik Elektro Vol 5, No 1 (2018): PRotek : Jurnal Ilmiah Teknik Elektro
Publisher : Program Studi Teknik Elektro Universitas Khairun

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33387/protk.v5i1.262

Abstract

Transformer is a vital equipment in the power system. If the transformer is damage, can cause the electrical distribution to the consumer will be disrupted. Therefore, it needs special maintenance the performance of the transformer to avoid damage. One of them is the maintenance of the transformer oil. During the operation, the transformer oil will experience about thermal and electrical loading. Due to the load can cause dissolved gases in oil that could potentially lead to a breakdown in the transformer. It is needed monitoring against these gases. The other way to analyze the gas dissolved in oil is by using Dissolved Gas Analysis (DGA) test. The DGA will extract gases to know indications based on the interpretation of the data were performed. Therefore, damage of the transformer can be prevented. The results of DGA analysis on the transformer were discharge of energy and thermal fault obtained from data interpretation using Ratio Roger and Duval Triangle method. Also, it can be known that, the results of water content testing indicate oil condition are good (water content 9 ppm).Keywords—Dissolved Gas Analysis, Oil Transfomer, Water Content, Rasio Roger, Duval Triangle.