Riyana.A
Politeknik Negeri Sriwijaya, Palembang

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

PENGEMBANGAN MODEL PREDICTIVE CONTROL UNTUK ALAT PENGELOS BENANG KAIN TAJUNG BERBASIS INTERNET OF THINGS Eka susanti eka Susanti; Herman Yani; R.A Halimahthus’dya; Bersiap Ginting; Riyana.A
JUTIM (Jurnal Teknik Informatika Musirawas) Vol. 11 No. 3 (2026): JUTIM (Jurnal Teknik Informatika Musirawas)
Publisher : LPPM UNIVERSITAS BINA INSAN

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32767/jutim.v11i3.3540

Abstract

The traditional thread-winding process for Palembang Tajung fabric still relies on manual operation, which may result in inconsistencies in winding speed and thread tension. This study aims to develop a prototype thread-winding machine based on the Internet of Things (IoT) that integrates the Model Predictive Control (MPC) method. The prototype uses an ESP32 microcontroller, an FC-03 optical sensor for rotational-speed measurement, a motor actuator, and the Blynk platform for remote monitoring. Testing involved rotational-speed measurements at 10 target thread lengths ranging from 50 to 500 cm, IoT communication-delay measurements at five observation times, and observations of wound thread length over time. The results show that the rotational-speed measurement errors listed in the table range from 0 to 0.49%. Meanwhile, according to the results table, IoT communication delays range from 0.8 to 2.2 seconds for uplink and from 1.1 to 2.4 seconds for downlink. The recorded wound thread lengths were 3, 8, 22, 30, 56, and 120 cm at observation times of 1, 5, 15, 30, 60, and 150 minutes, respectively. These results indicate that the prototype can perform rotational-speed measurements and support IoT-based monitoring. However, the available experimental data are insufficient to establish the effectiveness of MPC in maintaining stable thread tension or to demonstrate an increase in production speed compared with conventional methods. Therefore, further testing involving direct thread-tension measurements and performance comparisons with conventional thread-winding methods is required.