Article Per Year (5 Year)
p-Index From 2021 - 2026
0
P-Index
This Author published in this journals
All Journal Journal of Engineering and Technological Sciences
Wahab, Hassan A.
Faculty of Engineering and Technical Studies, University of Elimam Elmahdi, Kosti,
Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Regenerative Chatter Evaluation when Turning Nickel-based Superalloy GH4169 Using PCBN Cutting Tool Fadul Almula, Mubarak A.M.; Zhu, Haitao; Wahab, Hassan A.
Journal of Engineering and Technological Sciences Vol 51, No 4 (2019)
Publisher : ITB Journal Publisher, LPPM ITB

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1116.948 KB) | DOI: 10.5614/j.eng.technol.sci.2019.51.4.7

Abstract

Vibration during machining operation is a major issue that lowers cutting operation efficiency. Usually high cutting forces are encountered during machining processes, consequently shortening cutting tool lifetime. Thus, the metal removable rate is reduced and a poor surface finish is produced. This issue can be overcome by selecting proper cutting parameters (cutting speed, feed, and depth of cut), especially when machining difficult-to-cut materials at high cutting speed. In this paper, a two-degrees-of-freedom turning vibration model is introduced to study the vibration mode of the system when nickel-based superalloy GH4169 is turned at varying cutting depths. The effect of varying the cutting depth on system vibration was simulated using the Matlab/Simulink software. In addition, the model was experimentally tested on a numerical controlled lathe machine. The stable limit cutting depth and the main vibration directions of the system chatter were the responses that were investigated. The results show that the simulation provided a reasonable approximation of the experimental results.
Co-Authors Fadul Almula, Mubarak A.M. Zhu, Haitao