Claim Missing Document
Check
Articles

Found 2 Documents
Search

MCU NODE BASED BLOOD GROUP DETECTION EQUIPPED WITH AN AUTOMATIC SAMPLE STIRER Fatimang, St.; Rusmin, Nur Fadil
Jurnal Teknologi Elekterika Vol. 21 No. 1 (2024)
Publisher : Jurusan Teknik Elektro Politeknik Negeri Ujung Pandang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31963/elekterika.v21i1.4778

Abstract

Blood type detection tool is a tool that can help In reading blood groups, you can find out the type of group blood with use sensors Light And LED, so in use tool This be equipped Gearboxes as stirrer sample automatic Which Where fluid reagent antisera will stirred with sample blood using the ABO method, results in sensor readings will be displayed on the LCD and also on the application when using Nodes MCU as the microcontroller, based on results testing tool This use 3 person with group blood Which The same on each Blood group samples are A, B, AB, O by comparing groups blood on card identity And results testing Which Where the result can obtained results Which The same. With mark flat flat group blood A is 0.6 and 2.1. As for blood type B, it is 1.7 and 1.1. As for AB blood type is 0.9 and 1.1. And blood type O is 2,3 And 2,3. whereas For mark error Which obtained group blood A that is 0.5 error value for blood group B i.e. 0.5 error value for blood group AB i.e 0.6, And error value for blood type O namely 0.2.
TUBE SEALER BERBASIS MIKROKONTROLLER AT89S51 Fatimang, ST.
Jurnal INSTEK (Informatika Sains dan Teknologi) Vol 2 No 2 (2017): Volume 2, Nomor 2, oktober 2017
Publisher : Department of Informatics Engineering, Faculty of Science and Technology, Universitas Islam Negeri Alauddin, Makassar, Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (881.66 KB) | DOI: 10.24252/instek.v2i2.4022

Abstract

         Alat tube sealer merupakan alat yang dapat membantu dalam mengklem selang secara otomatis sehingga mempermudah dan menghemat waktu yang diperlukan. Alat ini memanfaatkan kecepatan dan kekuatan dorongan selenoid yang dapat dikontrol Melalui µC. Setelah alat dihidupkan heater akan memanaskan sesuai suhu yang dibutuhkan selama 5 menit baru alat bisa digunakan, solenoid akan menjepit apabila saklar pendeteksi selang tertekan, alat akan berhenti menekan selama waktu yang ditentukan, Suhu yang dibutuhkan pada alat ini 800C dan waktu lama penjepitan yaitu 0,5 detik, Nilai rata-rata perbedaan antara suhu heater dan thermostat adalah 1,33Kata Kunci : Tube Sealer