Article Per Year (5 Year)
p-Index From 2021 - 2026
0.61
P-Index
This Author published in this journals
All Journal International Journal of Electrical and Computer Engineering International Journal of Power Electronics and Drive Systems (IJPEDS) Indonesian Journal of Electrical Engineering and Computer Science
Ihsan Jabbar Hasan
Middle Technical University
Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering

Published : 5 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 3 Documents
Search
Journal : International Journal of Electrical and Computer Engineering

 1 
Comparison of cascade P-PI controller tuning methods for PMDC motor based on intelligence techniques Kareem Ghazi Abdulhussein; Naseer Majeed Yasin; Ihsan Jabbar Hasan
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 1: February 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i1.pp1-11

Abstract

In this paper, there are two contributions: The first contribution is to design a robust cascade P-PI controller to control the speed and position of the permanent magnet DC motor (PMDC). The second contribution is to use three methods to tuning the parameter values for this cascade controller by making a comparison between them to obtain the best results to ensure accurate tracking trajectory on the axis to reach the desired position. These methods are the classical method (CM) and it requires some assumptions, the genetic algorithm (GA), and the particle swarm optimization algorithm (PSO). The simulation results show the system becomes unstable after applying the load when using the classical method because it assumes cancellation of the load effect. Also, an overshoot of about 3.763% is observed, and a deviation from the desired position of about 12.03 degrees is observed when using the GA algorithm, while no deviation or overshoot is observed when using the PSO algorithm. Therefore, the PSO algorithm has superiority as compared to the other two methods in improving the performance of the PMDC motor by extracting the best parameters for the cascade P-PI controller to reach the desired position at a regular speed.
A global system for mobile communications-based electrical power consumption for a non-contact smart billing system Ihsan Jabbar Hasan; Bushra Mahmoud Waheib; Nahla Abdul Jalil Salih; Nadhir Ibrahim Abdulkhaleq
International Journal of Electrical and Computer Engineering (IJECE) Vol 11, No 6: December 2021
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v11i6.pp4659-4666

Abstract

This paper proposes a cheap solution to be a starting point for building smart electrical power billing systems. Electrical power has many challenges issues in Iraq, one of these challenges and the most important is the Billing system. The smart power meter uses an Arduino Uno as the core for controlling the sensed data and transmits it to the electrical power unit for billing services. The system is constructed with two parts: the transmitting unit measures the current, voltage, power and power factor through the compact new sensor PZEM-004T. The data sensed and processed by the microcontroller which displayed the KWh on (2*16 LCD) display. This data also transmitted to the electrical power company unit via the global system for mobile communications (GSM) module (SIM900A) which is a dual band GSM/GPRS-general packet radio service modem. The receiving part is mainly dedicated for collecting the required consumed power data via the same (SIM900A) module and also can display it using (2*16 LCD) display. For the sake of saving these data, the receiver part uses SD ram for such purposes. With such proposed system the electrical power company can control and collect their fees monthly without loss and with minimum cost.
Improving the data recovery for short length LT codes Nadhir Ibrahim Abdulkhaleq; Faeza Abbas Abed; Ihsan Jabbar Hasan; Falah Hasan Mahdi
International Journal of Electrical and Computer Engineering (IJECE) Vol 10, No 2: April 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (690.951 KB) | DOI: 10.11591/ijece.v10i2.pp1972-1979

Abstract

Luby Transform (LT) code is considered as an efficient erasure fountain code. The construction of the coded symbols is based on the formation of the degree distribution which played a significant role in ensuring a smooth decoding process. In this paper, we propose a new encoding scheme for LT code generation. This encoding presents a deterministic degree generation (DDG) with time hoping pattern which found to be suitable for the case of short data length where the well-known Robust Soliton Distribution (RSD) witnessed a severe performance degradation. It is shown via computer simulations that the proposed (DDG) has the lowest records for unrecovered data packets when compared to that using random degree distribution like RSD and non-uniform data selection (NUDS). The success interpreted in decreasing the overhead required for data recovery to the order of 25% for a data length of 32 packets.
Co-Authors Bushra Mahmoud Waheib Faeza Abbas Abed Falah Hasan Mahdi Kareem Ghazi Abdulhussein Majli Nema Hawas Mohannad Jabbar Mnati Nadhir Ibrahim Abdulkhaleq Nadhir Ibrahim Abdulkhaleq Nadhir Ibrahim Abdulkhaleq Nahla Abdul Jalil Salih Naseer Majeed Yasin