Article Per Year (5 Year)
p-Index From 2020 - 2025
0.23
P-Index
This Author published in this journals
All Journal International Journal of Electrical and Computer Engineering TELKOMNIKA (Telecommunication Computing Electronics and Control)
Khalifa Echchakhaoui
Hassan 1st University
Computer Science & IT Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
A new structure of a wide band bridge power limiter Khalifa Echchakhaoui; Elhassane Abdelmounim; Jamal Zbitou; Hamid Bennis
International Journal of Electrical and Computer Engineering (IJECE) Vol 10, No 4: August 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (565.387 KB) | DOI: 10.11591/ijece.v10i4.pp4035-4042

Abstract

In this work, new design and simulation of a microstrip power limiter based on Schottky diode is presented. The proposed circuit is a zero bias power limiter built by associating a transmission line in parallel to a four Schottky rectifier bridge circuit. The first circuit using a single stage rectifier is analyzed and simulated. To improve this single stage, a second and final limiter is designed with two stages rectifier. Simulation results for the final circuit show an ideal limiter behavior and good performance of limiting rate up to 20dB for a threshold input power varying from 5 dBm to 30 dBm. While insertion loss remains low at small signal.
A Novel Structure of a Wideband Zero-Bias Power Limiter for ISM Band Khalifa Echchakhaoui; Elhassane Abdelmounim; Jamal Zbitou; Hamid Bennis; Ahmed Errkik; Angel Mediavilla Sanchez
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 16, No 6: December 2018
Publisher : Universitas Ahmad Dahlan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.12928/telkomnika.v16i6.8730

Abstract

In this paper, a new broadband microwave microstrip power limiter is designed and realized. The Power Limiter is based on microstrip technology integrating a Zero Bias commercial Schottky diodes HSMS2820.The power limiter is optimized and validated in two steps. The enhanced and achieved circuit is obtained by concatenating two basic structures. The final circuit was validated into simulation by using ADS solver. Finally this circuit was realized and tested. Simulation and measurement results are in a good agreement. The final circuit achieves a limiting rate of 14 dB with a threshold input power level of 0 dBm until a maximum input power level of 30 dBm.
Co-Authors Ahmed Errkik Angel Mediavilla Sanchez Elhassane Abdelmounim Hamid Bennis Jamal Zbitou