Article Per Year (5 Year)
p-Index From 2020 - 2025
0.444
P-Index
This Author published in this journals
All Journal International Journal of Electrical and Computer Engineering International Journal of Power Electronics and Drive Systems (IJPEDS)
Amina Mahmoud Shakir
Al-Nahrain University
Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
An optimum location of on-grid bifacial based photovoltaic system in Iraq Amina Mahmoud Shakir; Siba Monther Yousif; Anas Lateef Mahmood
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 1: February 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i1.pp250-261

Abstract

Bifacial photovoltaic (PV) module can gain 30% more energy compared to monofacial if a suitable location were chosen. Iraq (a Middle East country) has a variable irradiation level according to its geographic coordinates, thus, the performance of PV systems differs. This paper an array (17 series, 13 parallel) was chosen to produce 100 kWp for an on-grid PV system. It investigates the PV system in three cities in Iraq (Mosul, Baghdad, and Basrah). Effect of albedo factor, high and pitch of the bifacial module on energy yield have been studied using PVsyst (software). It has been found that the effect is less for a pitch greater than 6 m. The energy gained from bifacial and monofacial PV system module in these cities shows that Mosul is the most suitable for installing both PV systems followed by Baghdad and lastly Basrah. However, in Basrah, the bifacial gain is 12% higher in the energy than monofacial as irradiation there is higher than the other locations, especially for elevation above 1.5 m. Moreover, the cost of bifacial array is 7.23% higher than monofacial, but this additional cost is acceptable since the bifacial gain is about 11.3% higher energy compared to the monofacial.
Photovoltaic array maximum power point tracking via modified perturbation and observation algorithm Bahaa Abdulkhaliq Numan; Amina Mahmoud Shakir; Anas Lateef Mahmood
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 11, No 4: December 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v11.i4.pp2007-2018

Abstract

One drawback of PVs is their low efficiency. As the PVs have a unique maximum Power Point for a specified irradiation level, there must be an effective method for extracting maximum power from the PV module to raise the efficiency. Conventional Perturbation and Observation (P&O) is a simple algorithm for maximum power point tracking (MPPT) but it suffers from oscillation during steady state conditions and is deviated from the maximum power point during slow and rapid irradiation level change. This paper presents a modified P&O by adding variation in PV current as a third in addition to the voltage and power variation parameters. This new algorithm is capable of eliminating the MPPT deviation. To increase the perturbation speed, a double step is taken as the tracking is deviated from the MPP. The modified P&O algorithm is used to control the duty cycle of DC-DC buck converter. The simulation shows that the modified P&O is faster than the conventional. The power loss due to oscillation before attaining the steady state is less for modified P&O. For slow irradiation level change (ramp up 600 to 1000 and ramp down 1000-800) W/m2, the modified P&O shows less tracking diverge. As the irradiation level changes rapidly from 800 to 200 W/m2, it's shown that the modified algorithm attains the steady state faster than the conventional P&O and the average efficiency increased by 4.34%.
Co-Authors Anas Lateef Mahmood Bahaa Abdulkhaliq Numan Siba Monther Yousif