Article Per Year (5 Year)
p-Index From 2021 - 2026
0.23
P-Index
This Author published in this journals
All Journal International Journal of Electrical and Computer Engineering Indonesian Journal of Electrical Engineering and Computer Science
Musa A. Hameed
Tikrit University
Computer Science & IT Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Design and implementation of an oil leakage monitoring system based on wireless network Jamal A. Hameed; Amer T. Saeed; Mohammed M. Sultan; Musa A. Hameed
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 3: June 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i3.pp2626-2635

Abstract

Monitoring pipeline leaks is one of the recent hot studies. Leakage may occur because of time corrosion in the tube raw materials. To reduce the negative consequences of this leak, an effective leak detection system is used to prevent serious leakage accidents and damage in oil pipelines. Buildings, ecosystems, air pollution, and human life are all at risk in case of leakage occurs which could lead to fires. This paper introduces one of the research methods for the detection of pipeline leaks with a particular focus on software-based methods. The computer board interface (CBI) and wireless sensor networks have been used beside Arduino as a micro-monitor for the entire system. ZigBee is also utilized to send read data from sensors to the monitoring system displayed on the LabVIEW graphical user interface (GUI). The operator can take direct action when a leak occurs. The effectiveness of the leakage monitoring process and its practical use are demonstrated by the introduction of computerized techniques based on pressure gauge analysis on a specific pipeline in the laboratory. The result showed that the system is widely covered, accurate data transmission and robust real-time performance which reduces economic losses and environmental pollution.
Eliminating unwanted signals in sound by using digital signal processing system Amer T Saeed; Zaid Raad Saber; Ahmed M. Sana; Musa A. Hameed
Indonesian Journal of Electrical Engineering and Computer Science Vol 18, No 2: May 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v18.i2.pp829-834

Abstract

Unwanted signals or noise signals in sound files are considered one of the major challenges and issues for a thousand users. It is impossible to reduce or remove these noise signals without identifying their types and ranges. Therefore, to address one of the big problems in the digital or analogue communication, which is noise signals or unwanted signals, an adaptive selection method and noise signal removal algorithm are proposed in this research. The proposed algorithm is done through specifying the types of undesirable signals, frequency, and time range, then utilizing digital signal processing system which includes design several types of digital filters based on the types and numbers of unwanted signals. Four digital filters are used in this research to remove noise signals from the sound file by implementing the proposed algorithm using Matlab Code. Results show that our proposed algorithm was done successfully and the whole noise signals were removed without any negative consequence in the output sound signal. Unwanted signals or noise signals in sound files are considered one of the major challenges and issues for a thousand users. It is impossible to reduce or remove these noise signals without identifying their types and ranges. Therefore, to address one of the big problems in the digital or analogue communication, which is noise signals or unwanted signals, an adaptive selection method and noise signal removal algorithm are proposed in this research. The proposed algorithm is done through specifying the types of undesirable signals, frequency, and time range, then utilizing digital signal processing system which includes design several types of digital filters based on the types and numbers of unwanted signals. Four digital filters are used in this research to remove noise signals from the sound file by implementing the proposed algorithm using Matlab Code. Results show that our proposed algorithm was done successfully and the whole noise signals were removed without any negative consequence in the output sound signal.
Co-Authors Ahmed M. Sana Amer T Saeed Amer T. Saeed Jamal A. Hameed Mohammed M. Sultan Zaid Raad Saber