Muhammad Ramlee Kamarudin
Universiti Teknologi Malaysia

Published : 3 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 3 Documents
Search

5G Fixed Beam Switching on Microstrip Patch Antenna Low Ching Yu; Muhammad Ramlee Kamarudin
International Journal of Electrical and Computer Engineering (IJECE) Vol 7, No 2: April 2017
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (736.468 KB) | DOI: 10.11591/ijece.v7i2.pp975-980

Abstract

5G technology is using millimeter-wave band to improve the wireless communication system.  However, narrow transmitter and receiver beams have caused the beam coverage area to be limited. Due to propagation limitations of mm wave band, beam forming technology with multi-beam based communication system, has been focused to overcome the problem. In this letter, a fixed beam switching method is introduced. By changing the switches, four different configurations of patch array antennas are designed to investigate their performances in terms of radiation patterns, beam forming angle, gain, half-power bandwidth and impedance bandwidth at 28 GHz operating frequency for 5G application. Mircostrip antenna is preferred due to its low profile, easy in feeding and array configurations. Three different beam directions had been formed at -15°, 0°, and 15° with half-power bandwidth of range 45˚ to 50˚.
Design of Planar Dielectric Resonator Antenna Array at 28 GHz Nuramirah Mohd Nor; Mohd Haizal Jamaluddin; Muhammad Ramlee Kamarudin; Siti Zareen Naqiyah Zool Ambia
Indonesian Journal of Electrical Engineering and Computer Science Vol 5, No 3: March 2017
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v5.i3.pp622-627

Abstract

This article presents a planar array of rectangular Dielectric Resonator Antenna operating for 28 GHz applications. The proposed antenna is formed through two stages of designs which are a single element and planar array. It is made up from a ceramic material with a dielectric constant of 10 and mounted on RT/Duroid 5880 with a relative permittivity of 2.2 and a thickness of 0.254 mm. A prospective study using three different configurations of three by three planar array is done in order to obtain the best performance in terms of bandwidth, gain, and cost reduction. Besides that, this study is also conducted for a beam steering capability of each configuration. Finally, the best configuration is proposed for 5G application.
Higher-order Mode Rectangular Dielectric Resonator Antenna for 5G Applications Nor Hidayu Shahadan; Muhammad Ramlee Kamarudin; Mohd Haizal Jamaluddin; Yoshihide Yamada
Indonesian Journal of Electrical Engineering and Computer Science Vol 5, No 3: March 2017
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v5.i3.pp584-592

Abstract

The excitation of the higher-order mode, in rectangular dielectric resonator designed was explored to enhance the antenna gain and detailed elaboration is presented in this paper. The antenna was fed by a 50Ω microstrip line through an aperture cut in the ground plane. Besides avoiding spurious radiation, this feeding technique gives flexibility in controlling the amount of coupling in order to reduce the Q-factor in the higher-order mode RDRA. A design was developed and subsequently simulated using Ansoft HFSS ver 16.0 by utilizing Duroid 5880 dielectric substrate with a thickness (ts) of 0.254 mm, a permittivity (εs) of 2.2 and a loss tangent (δ) of 0.001 at 15 GHz. The higher-order mode, RDRA achieved the measured gain at 9.76 dBi and the measured impedance bandwidth as much 2.5 GHz which is 4.7% more compared to the fundamental mode. The result should be considered suitable for 5G applications.