Garuda - Garba Rujukan Digital

p-Index From 2021 - 2026

P-Index

This Author published in this journals

All Journal International Journal of Power Electronics and Drive Systems (IJPEDS) Indonesian Journal of Electrical Engineering and Computer Science

Byamakesh Nayak

KIIT University

Author-ID : 2397274

Control & Systems Engineering Electrical & Electronics Engineering

Published : 6 Documents Claim Missing Document

Claim Missing Document

Articles

Parameter estimation of DC motor through whale optimization algorithm Byamakesh Nayak; Sangeeta Sahu
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 10, No 1: March 2019
Publisher : Institute of Advanced Engineering and Science

This article estimates the unknown dc motor parameters by adapting the adaptive model with the reference model created by experimental data onto armature current and speed response from separately excited dc motor .The field flux dynamics, which is usually ignored, is included to model the dynamics of the motor. The block diagram including the flux dynamics and model parameters is considered as the adaptive model. The integral time square error between the instant experimental data and the corresponding adaptive model data is taken as cost function. The Whale optimization algorithm is used to minimize the cost function. Additionally, to improve the performances of optimization algorithm and for accurate result, the experimental data is divided into three intervals which form the three inequality constraints. A fixed penalty value is added to the cost function for violating these constraints. The effectiveness of estimation with two different methods is validated by convergence curve.

Selective Harmonic Elimination of an Eleven Level Inverter Using Whale Optimization Technique Srikanta Kumar Dash; Byamakesh Nayak; Jiban Ballav Sahu
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 9, No 4: December 2018
Publisher : Institute of Advanced Engineering and Science

Reduction of total harmonic distortion in multilevel inverters is a difficult optimization problem that includes nonlinear transcendent equations having more than one local minima.This paper deals with the harmonic elimination of cascaded multilevel inverter with equal D.C. sources using a new optimization technique. The objective of this paper is to find the best combination of switching angles to minimize the lower order harmonics and the total harmonic distortion is reduced. For this purpose, a new optimization techniques i.e. whale optimization technique is considered.This algorithm is applied to an 11-level cascaded H-bridge inverter.Results shows that WOA gives better results and effectively minimizes the THD and lower order harmonics

Proposed Method for Shoot-Through in Three Phase ZSI and Comparison of Different Control Techniques Byamakesh Nayak; Saswati Swapna Dash; Subrat Kumar
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 5, No 1: 2014
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar

This paper presented the new methodology for different control techniques applied to three phase Z-source inverter for minimisation of switching losses. The procedure for proposed control techniques and its effects on the performance of operation of three phase Z-source inverter are analyzed. The graphs for voltage gain and voltage stress are drawn for different control methods. The flow-chart for the symmetrical and unsymmetrical control techniques for creating pulse signals for switches of three phase inverter are shown. All the methods are studied and compared with each other. The Total harmonic distortion (THD) of output voltage of both the control methods has been analyzed using FFT analysis. The experiments done and the results shown for capacitor voltage, load current and load line voltage for simple boost and constant boost control techniques are presented using MATLAB/ Simulink.DOI: http://dx.doi.org/10.11591/ijpeds.v5i1.6180

Modeling & Analysis of a Novel Adaptive Hysteresis Band Controller for Boost and Buck Converter Tanmoy Roy Choudhury; Byamakesh Nayak
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 8, No 1: March 2017
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v8.i1.pp305-315

In this paper, a new topology of Adaptive Hysteresis Band controller for Boost & Buck converter has been proposed, modeled and analyzed. The difficulties caused in Hysteresis Band (HB) controlled dc-dc converter have been eliminated using Adaptive Hysteresis Band (AHB) controller. This novel control topology can be able to maintain the switching frequency constant unlike HB controller. Thus the filter design for the converters will become easier with this controller. Again this control methodology is a robust one as it depends upon the system parameters where there was no possibility with HB controller. The Mathematical modeling of the controller is shown in this paper, further this has been simulated using Matlab /SIMULINK to generate pulse. The steady state analysis to find the parameters and the stability condition of the converter using the dynamic behavior is also portrayed in this paper. The simulation for a Boost and a Buck converter is also shown separately using AHB controller.

Comparative Steady State Analysis of Boost and Cascaded Boost Converter with Inductive ESR losses & Capacitor Current Behaviour Tanmoy Roy Choudhury; Byamakesh Nayak
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 7, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

In this paper, an overall comparison between the Boost Converter (BC) & Cascaded Converter/ Cascaded Boost Converter (CBC) has been depicted in terms of ideal condition, as well as with the consideration of Equivalent Series Resistance (ESR) of inductor(s). The loss comparison in the two converters due to the ESR is also included in this paper. It can be seen that in CBC, voltage gain is more but the power loss due to ESR is also more compared to BC. The parameters of the converters are derived with a consideration of per unit ripple quantity of inductor current and capacitor voltage. A boundary condition between the continuous conduction mode (CCM) & discontinuous conduction mode (DCM) of the inductor current is also shown. The behaviour of the capacitor current for the converters is discussed during ON and OFF condition of the switch(es) during DCM. At the end, the simulation results of both the converters are given for a 20V/100V, 100 W output. The analysis and simulation results are presented in this paper for the verification of the feasibility.

Parameter Estimation of DC Motor using Adaptive Transfer Function Based on Nelder-Mead Optimisation Byamakesh Nayak; Sangeeta Sahu; Tanmoy Roy Choudhury
Indonesian Journal of Electrical Engineering and Computer Science Vol 9, No 3: March 2018
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v9.i3.pp696-702

This paper explains an adaptive method for estimation of unknown parameters of transfer function model of any system for finding the parameters. The transfer function of the model with unknown model parameters is considered as the adaptive model whose values are adapted with the experimental data. The minimization of error between the experimental data and the output of the adaptive model have been realised by choosing objective function based on different error criterions. Nelder-Mead optimisation Method is used for adaption algorithm. To prove the method robustness and for students learning, the simple system of separately excited dc motor is considered in this paper. The experimental data of speed response and corresponding current response are taken and transfer function parameters of dc motors are adapted based on Nelder-Mead optimisation to match with the experimental data. The effectiveness of estimated parameters with different objective functions are compared and validated with machine specification parameters.

Co-Authors Jiban Ballav Sahu Sangeeta Sahu Saswati Swapna Dash Srikanta Kumar Dash Subrat Kumar Tanmoy Roy Choudhury

Title

Found 6 Documents
Search

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Title Search

Found 6 Documents Search

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Title

Found 6 Documents
Search