Claim Missing Document
Check
Articles

Found 2 Documents
Search

Improvement Potential and Exergy Analyses of Photovoltaic Thermal with and without ∇-absorber Collector Saprizal Hadisaputra; Muhammad Zohri; Hardani Hardani; Ahmad Fudholi
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 9, No 4: December 2018
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v9.i4.pp1792-1798

Abstract

The combination of a solar thermal and photovoltaic system is called photovoltaic thermal system (PVT). The PVT system with and without -absorber has been intended to harvest both hot air and electricity. The hot air that is produced is used in the cooling process of the photovoltaic panel and then to improve the efficiency of the photovoltaic panel. The experimental investigation was conducted at the mass flow rate from 0.0069 kg/s to 0.0491 kg/s and solar radiation of 522 W/m2 and 820 W/m2 in the National University of Malaysia. The using -absorber collector increases exergy and exergy efficiency of PVT system. The improvement potential comparatively upsurges with cumulative the mass flow rate.
Exergy Assessment of Photovoltaic Thermal with V-groove Collector Using Theoretical study Muhammad Zohri; Nurato Nurato; Lalu Darmawan Bakti; Ahmad Fudholi
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 16, No 2: April 2018
Publisher : Universitas Ahmad Dahlan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.12928/telkomnika.v16i2.8433

Abstract

The solution of the environmental problems because of fuel fossil is to use new and renewable energy. There are many studies about energy analysis of solar collector with v-groove but exergy analysis of photovoltaic thermal system with v-groove is still less especially by theoretical study. Photovoltaic thermal with v-groove collector has been conducted the exergy analysis by theoretical assessment. The matrix inversion methods were used to analyze the energy balance equation. The theoretical assessment was conducted under the solar intensity of 385 W/m2, 575 W/m2, and 875 W/m2 and mass flow rate between 0.01 and 0.05 kg/s. The maximum exergy efficiency and exergy of PVT system with v-groove collector were 17.80% and 86.32 Watt at the solar intensity of 875 W/m2.