Article Per Year (5 Year)
p-Index From 2020 - 2025
0.444
P-Index
This Author published in this journals
All Journal International Journal of Power Electronics and Drive Systems (IJPEDS) Indonesian Journal of Electrical Engineering and Computer Science
Jasrul Jamani Jamian
Universiti Teknologi Malaysia
Control & Systems Engineering Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Photovoltaic emulator using error adjustment fuzzy logic proportional-integral controller Razman Ayop; Chee Wei Tan; Shahrin Md Ayob; Nik Din Muhamad; Jasrul Jamani Jamian; Zulkarnain Ahmad Noorden
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 13, No 2: June 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v13.i2.pp1111-1118

Abstract

The photovoltaic (PV) technology has been increasingly used in our energy generation. Therefore, it is essential to have a good PV testing facility during the development process. The PV emulator (PVE) is a voltage or current source that mimic the current-voltage characteristic as a PV module that requires proper control strategy to work. The resistance feedback method (RFM) control strategy has many good attributes, except the transient response, which is caused by the proportional-integral (PI) controller. This paper proposed a new fuzzy logic PI (FLPI) controller to improve the transient performance of the RFM PVE. It is based on the error adjustment method that founded on the transient state and load of the PVE. The performance of the proposed PVE is compared with the original PVE that used RFM with the PI controller. The finding of the research shows that the transient performance of the proposed PVE has improved 2.3 times compared to the original PVE without affecting its accuracy.
Electrochemical properties of kenaf-derived activated carbon electrodes under different activation time durations for supercapacitor application Muhammad Nizam Abdul Razak; Zulkarnain Ahmad Noorden; Farid Nasir Ani; Zulkurnain Abdul Malek; Jasrul Jamani Jamian; Nouruddeen Bashir
Indonesian Journal of Electrical Engineering and Computer Science Vol 19, No 2: August 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v19.i2.pp1105-1112

Abstract

The electrochemical properties of supercapacitors with kenaf-derived activated carbon electrodes under different activation time durations were evaluated. The study aims to determine the optimum activation time required that contributes to highest supercapacitor’s perfomance. Kenaf fibre was firstly carbonized at 400 °C to remove its water content and any volatile substances. The resulted kenaf-derived carbon was then impregnated in potassium hydroxide (KOH) with 4:1 impregnation ratio and left overnight. After the impregnation process, the carbon sample was activated at 600 °C with different heating time durations of 1, 2, 3 and 4 hours and named as A600-1, A600-2, A600-3 and A600-4, repectively. Four supercapacitors with the kenaf-derived activated carbon samples as the electrodes were fabricated based on two-electrode symmetrical test cell system. Specific capacitances of 108, 189, 242, and 126 F/g for supercapacitors with activated carbon A600-1, A600-2, A600-3 and A600-4 electrodes, respectively were achieved. These were much higher than previously reported values of only up to 37 F/g. The finding suggests that an inexpensive fibrous carbon material derived from kenaf by a facile pyrolysis process may be a remarkable choice to construct high performance supercapacitor.
Co-Authors Chee Wei Tan Farid Nasir Ani Muhammad Nizam Abdul Razak Nik Din Muhamad Nouruddeen Bashir Razman Ayop Shahrin Md Ayob Zulkarnain Ahmad Noorden Zulkarnain Ahmad Noorden Zulkurnain Abdul Malek