Article Per Year (5 Year)
p-Index From 2021 - 2026
0.408
P-Index
This Author published in this journals
All Journal International Journal of Applied Power Engineering (IJAPE)
Sapavath Sreenu
Osmania University
Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : international journal of applied power engineering ijape

 1 
Implementation and study of fuzzy based KY boost converter for electric vehicle charging Jalla Upendar; Sangem Ravi Kumar; Sapavath Sreenu; Bogimi Sirisha
International Journal of Applied Power Engineering (IJAPE) Vol 11, No 1: March 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (839.233 KB) | DOI: 10.11591/ijape.v11.i1.pp98-108

Abstract

Elecetric vehicle batteries require direct current (DC) current for charging; hence the circuit alternating current (AC) is converted to DC by a battery charger. Battery charger mostly consists of a rectifier and DC-DC converter with a controller built in to serve as a protective circuit. A harmonic source load is a type of electric car charger. During the AC-DC change over method, harmonic current is introduced into the power system, affecting power quality. In this study, a charging station consisting of buck boost and a charging station consisting a KY Boost converter were simulated. To maintain output voltage of DC-DC converters constant controller is used, the controller is either PI or fuzzy logic controller. So, four models are developed and simulated which are buck-boost converter controlled by proportional-integral (PI)-controller, KY-boost converter controlled by proportional integral-controller, buck boost converter controller fuzzy logic controller and KY boost-converter controlled by fuzzy logic controller. The total harmonic distortion (THD) of the four models is compared.
Analysis of switched impedance source/quasi-impedance source DC-DC converters for photovoltaic system Sapavath Sreenu; Jalla Upendar; Bogimi Sirisha
International Journal of Applied Power Engineering (IJAPE) Vol 11, No 1: March 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1077.466 KB) | DOI: 10.11591/ijape.v11.i1.pp14-24

Abstract

This paper proposes the switched impedance source converter (SZSC) or switched quasi impedance source DC-DC converter (S-qZSC) based photovoltaic (PV) grid-connected systems. To increase the voltage from low level to high level, all PV grid-connected systems need step-up DC-DC converters. This step-up factor can be increased by connecting the terminals of a traditional quasi impedance source DC-DC converter with an additional diode and a switch. In this proposed converter, the capacitor not only serves as a filter. It is, however, bound in series to the charging loops of the inductors. On the one hand, saturated inductors can trigger instability, which can be avoided. When used for dc-ac conversion, however, the modulation index of the backend H-bridge can be set to a wider range. As compared to existing Z-source-based systems, a shorter duty period results in a higher boost factor.
Co-Authors Bogimi Sirisha Jalla Upendar Sangem Ravi Kumar