Article Per Year (5 Year)
p-Index From 2020 - 2025
0.23
P-Index
This Author published in this journals
All Journal Bulletin of Electrical Engineering and Informatics Bulletin of Electrical Engineering and Informatics Bulletin of Electrical Engineering and Informatics Indonesian Journal of Electrical Engineering and Computer Science
M. N. Abdullah
Universiti Tun Hussein Onn Malaysia
Computer Science & IT Electrical & Electronics Engineering Engineering

Published : 8 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search
Journal : Bulletin of Electrical Engineering and Informatics

 1 
Estimation of Photovoltaic Module Parameters based on Total Error Minimization of I-V Characteristic M. N. Abdullah; M. Z. Hussin; S. A. Jumaat; N. H. Radzi; Lilik J. Awalin
Bulletin of Electrical Engineering and Informatics Vol 7, No 3: September 2018
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (597.456 KB) | DOI: 10.11591/eei.v7i3.1274

Abstract

Mathematical Modelling of photovoltaic (PV) modules is important for simulation and performance analysis of PV system. Therefore, an accurate parameters estimation is necessary. Single-diode and two-diode model are widely used to model the PV system. However, it required to determine several parameters such as series and shunt resistances that not provided in datasheet.  The main goal of PV modelling technique is to obtain the accurate parameters to ensure the I-V characteristic is closed to the manufacturer datasheet. Previously, the maximum power error of calculated and datasheet value are considered as objective to be minimized for both models. This paper proposes the PV parameter estimation model based minimizing the total error of open circuit voltage (VOC), short circuit current (ISC) and maximum power (PMAX) where all these parameters are provided by the manufacturer. The performance of single-diode and two-diode models are tested on different type of PV modules using MATLAB. It found that the two-diode model obtained accurate parameters with smaller error compared to single-diode model. However, the simulation time is slightly higher than single-diode model due extra calculation required.
Co-Authors A. F. A. Manan A. H. Abu Bakar Ahmad Fateh Mohamad Nor Bazilah Ismail Fatini Fatini J. J. Jamian L.T. Tay Lilik J. Awalin Lilik J. Awalin M. Fairuz Ab. Hamid M. Z. Hussin N. A. Abdullah N. F. Aswan N. H. Radzi N. Z. Mohamad Nur Anis Athirah S. A. Jumaat