Garuda - Garba Rujukan Digital

Microstrip patch antenna with defected ground structure for biomedical application Md. Shazzadul Islam; Muhammad I. Ibrahimy; S. M. A. Motakabber; A. K. M. Zakir Hossain; S. M. Kayser Azam
Bulletin of Electrical Engineering and Informatics Vol 8, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

Proper narrowband antenna design for wearable devices in the biomedical application is a significant field of research interest. In this work, defected ground structure-based microstrip patch antenna has been proposed that can work for narrowband applications. The proposed antenna works exactly for a single channel of ISM band. The resonant frequency of the antenna is 2.45 GHz with a return loss of around -30 dB. The -10dB impedance bandwidth of the antenna is 20 MHz (2.442-2.462 GHz), which is the bandwidth of channel 9 in ISM band. The antenna has achieved a high gain of 7.04 dBi with an increase of 17.63% antenna efficiency in terms of realized gain by using defected ground structure. Three linear vector arrays of arrangement 1 2, 1 4 and 1 8 have been designed to validate the proposed antenna performances as an array. The proposed antenna is light weighted, low cost, easy to fabricate and with better performances that makes it suitable for biomedical WLAN applications.

A miniaturized hairpin resonator for the high selectivity of WLAN bandwidth S. M. Kayser Azam; Muhammad I. Ibrahimy; S. M. A. Motakabber; A. K. M. Zakir Hossain; Md. Shazzadul Islam
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

In this article, a miniaturized hairpin resonator has been presented to introduce the high selectivity of Wireless Local Area Network (WLAN) bandwidth. In the construction of the hairpin resonator, short-circuited comb-lines are electrically coupled with the two longer edges of a rectangular-shaped loop. The hairpin resonator has been designed and fabricated with the Taconic TLX-8 substrate with a center-frequency at 2.45 GHz. The resonator exhibits a second order quasi-Chebyshev bandpass response. A low insertion loss has been found as -0.36 dB with a minimum return loss as -36.71 dB. The filtering dimension of this hairpin resonator occupies a small area of 166.82 mm2. This hairpin resonator is highly selective for the bandpass applications of the entire WLAN bandwidth.

Design and implementation of a series switching SPSI for PV cell to use in carrier based grid synchronous system Tawfikur Rahman; S. M. A. Motakabber; Muhammad I. Ibrahimy; A. H. M. Zahirul Alam
Bulletin of Electrical Engineering and Informatics Vol 8, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

A carrier-based grid synchronous method is proposed to develop the system efficiency, phase and power quality of the inverter output waves. The operating principle of a single-phase phase synchronous inverter (SPSI) is introduced, with proper synchronous paid to the switching-frequency synchronizing voltage made by the interleaved process, as well as actual mitigation approaches. In the construction of the SPSI, input and output filters are electrically coupled with the two sides of an inverter. The inverter power electronic switches and other electrical components are operated by carrier-based grid synchronous controller (CBGSC) with PWM regulator. The SPSI is designed and implemented with the Toshiba 40WR21 IGBT, Digital Microcontroller pulse controller (DMPC) and 4N35 Optocoupler with a fundamental frequency of 50Hz. The other parameters are considered as load resistance, =11Ω, duty cycle, 85%, carrier frequency, 2.5kHz and input DC voltage, ± 340V. In addition, LCL lowpass grid filters are used to convert squire wave to sine wave with required phase and frequency. Finally, the simulated and experimental results obtained with a carrier-based grid synchronous SPSI experimental prototype are exposed for justification, showing the phase error of 55% improvement, reduced 11% of THD and the conversion efficiency of 97.02% highly predicted by the proposed design technique to improve the microgrid system.

Microstrip patch antenna with defected ground structure for biomedical application Md. Shazzadul Islam; Muhammad I. Ibrahimy; S. M. A. Motakabber; A. K. M. Zakir Hossain; S. M. Kayser Azam
Bulletin of Electrical Engineering and Informatics Vol 8, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

Proper narrowband antenna design for wearable devices in the biomedical application is a significant field of research interest. In this work, defected ground structure-based microstrip patch antenna has been proposed that can work for narrowband applications. The proposed antenna works exactly for a single channel of ISM band. The resonant frequency of the antenna is 2.45 GHz with a return loss of around -30 dB. The -10dB impedance bandwidth of the antenna is 20 MHz (2.442-2.462 GHz), which is the bandwidth of channel 9 in ISM band. The antenna has achieved a high gain of 7.04 dBi with an increase of 17.63% antenna efficiency in terms of realized gain by using defected ground structure. Three linear vector arrays of arrangement 1 2, 1 4 and 1 8 have been designed to validate the proposed antenna performances as an array. The proposed antenna is light weighted, low cost, easy to fabricate and with better performances that makes it suitable for biomedical WLAN applications.

A miniaturized hairpin resonator for the high selectivity of WLAN bandwidth S. M. Kayser Azam; Muhammad I. Ibrahimy; S. M. A. Motakabber; A. K. M. Zakir Hossain; Md. Shazzadul Islam
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

In this article, a miniaturized hairpin resonator has been presented to introduce the high selectivity of Wireless Local Area Network (WLAN) bandwidth. In the construction of the hairpin resonator, short-circuited comb-lines are electrically coupled with the two longer edges of a rectangular-shaped loop. The hairpin resonator has been designed and fabricated with the Taconic TLX-8 substrate with a center-frequency at 2.45 GHz. The resonator exhibits a second order quasi-Chebyshev bandpass response. A low insertion loss has been found as -0.36 dB with a minimum return loss as -36.71 dB. The filtering dimension of this hairpin resonator occupies a small area of 166.82 mm2. This hairpin resonator is highly selective for the bandpass applications of the entire WLAN bandwidth.

Design and implementation of a series switching SPSI for PV cell to use in carrier based grid synchronous system Tawfikur Rahman; S. M. A. Motakabber; Muhammad I. Ibrahimy; A. H. M. Zahirul Alam
Bulletin of Electrical Engineering and Informatics Vol 8, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

A carrier-based grid synchronous method is proposed to develop the system efficiency, phase and power quality of the inverter output waves. The operating principle of a single-phase phase synchronous inverter (SPSI) is introduced, with proper synchronous paid to the switching-frequency synchronizing voltage made by the interleaved process, as well as actual mitigation approaches. In the construction of the SPSI, input and output filters are electrically coupled with the two sides of an inverter. The inverter power electronic switches and other electrical components are operated by carrier-based grid synchronous controller (CBGSC) with PWM regulator. The SPSI is designed and implemented with the Toshiba 40WR21 IGBT, Digital Microcontroller pulse controller (DMPC) and 4N35 Optocoupler with a fundamental frequency of 50Hz. The other parameters are considered as load resistance, =11Ω, duty cycle, 85%, carrier frequency, 2.5kHz and input DC voltage, ± 340V. In addition, LCL lowpass grid filters are used to convert squire wave to sine wave with required phase and frequency. Finally, the simulated and experimental results obtained with a carrier-based grid synchronous SPSI experimental prototype are exposed for justification, showing the phase error of 55% improvement, reduced 11% of THD and the conversion efficiency of 97.02% highly predicted by the proposed design technique to improve the microgrid system.

Design and implementation of a series switching SPSI for PV cell to use in carrier based grid synchronous system Tawfikur Rahman; S. M. A. Motakabber; Muhammad I. Ibrahimy; A. H. M. Zahirul Alam
Bulletin of Electrical Engineering and Informatics Vol 8, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

A carrier-based grid synchronous method is proposed to develop the system efficiency, phase and power quality of the inverter output waves. The operating principle of a single-phase phase synchronous inverter (SPSI) is introduced, with proper synchronous paid to the switching-frequency synchronizing voltage made by the interleaved process, as well as actual mitigation approaches. In the construction of the SPSI, input and output filters are electrically coupled with the two sides of an inverter. The inverter power electronic switches and other electrical components are operated by carrier-based grid synchronous controller (CBGSC) with PWM regulator. The SPSI is designed and implemented with the Toshiba 40WR21 IGBT, Digital Microcontroller pulse controller (DMPC) and 4N35 Optocoupler with a fundamental frequency of 50Hz. The other parameters are considered as load resistance, =11Ω, duty cycle, 85%, carrier frequency, 2.5kHz and input DC voltage, ± 340V. In addition, LCL lowpass grid filters are used to convert squire wave to sine wave with required phase and frequency. Finally, the simulated and experimental results obtained with a carrier-based grid synchronous SPSI experimental prototype are exposed for justification, showing the phase error of 55% improvement, reduced 11% of THD and the conversion efficiency of 97.02% highly predicted by the proposed design technique to improve the microgrid system.

Microstrip patch antenna with defected ground structure for biomedical application Md. Shazzadul Islam; Muhammad I. Ibrahimy; S. M. A. Motakabber; A. K. M. Zakir Hossain; S. M. Kayser Azam
Bulletin of Electrical Engineering and Informatics Vol 8, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

Proper narrowband antenna design for wearable devices in the biomedical application is a significant field of research interest. In this work, defected ground structure-based microstrip patch antenna has been proposed that can work for narrowband applications. The proposed antenna works exactly for a single channel of ISM band. The resonant frequency of the antenna is 2.45 GHz with a return loss of around -30 dB. The -10dB impedance bandwidth of the antenna is 20 MHz (2.442-2.462 GHz), which is the bandwidth of channel 9 in ISM band. The antenna has achieved a high gain of 7.04 dBi with an increase of 17.63% antenna efficiency in terms of realized gain by using defected ground structure. Three linear vector arrays of arrangement 1 2, 1 4 and 1 8 have been designed to validate the proposed antenna performances as an array. The proposed antenna is light weighted, low cost, easy to fabricate and with better performances that makes it suitable for biomedical WLAN applications.

A miniaturized hairpin resonator for the high selectivity of WLAN bandwidth S. M. Kayser Azam; Muhammad I. Ibrahimy; S. M. A. Motakabber; A. K. M. Zakir Hossain; Md. Shazzadul Islam
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

In this article, a miniaturized hairpin resonator has been presented to introduce the high selectivity of Wireless Local Area Network (WLAN) bandwidth. In the construction of the hairpin resonator, short-circuited comb-lines are electrically coupled with the two longer edges of a rectangular-shaped loop. The hairpin resonator has been designed and fabricated with the Taconic TLX-8 substrate with a center-frequency at 2.45 GHz. The resonator exhibits a second order quasi-Chebyshev bandpass response. A low insertion loss has been found as -0.36 dB with a minimum return loss as -36.71 dB. The filtering dimension of this hairpin resonator occupies a small area of 166.82 mm2. This hairpin resonator is highly selective for the bandpass applications of the entire WLAN bandwidth.

A Series Regeneration Converter Technique for Voltage Balancing of Energy Storage Devices A K M Ahasan Habib; S. M. A. Motakabber; Muhammad I. Ibrahimy
Indonesian Journal of Electrical Engineering and Computer Science Vol 8, No 2: November 2017
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v8.i2.pp475-481

A single series resonant converter has been designed to balance the voltage level of a storage battery for electric vehicles. The proposed design has been simulated and verified by using two 100F supercapacitors instate of the conventional rechargeable battery. A voltage monitoring circuit detects the voltage condition of the individual capacitor and sends the voltage status to the control circuit for action. A technique has been developed to control a set of switches to transfer the current between the capacitor to balance the voltage level. The MATLAB simulated result shows the balancing circuit decreases the voltage difference between the two supercapacitors from 200 mV to 0V in 140 seconds, which is less than the existing methods. This fast voltage balancing technique can be used in the battery management system or electric vehicles for long lasting the battery life. Keywords: Voltage balancing; electric vehicles; supercapacitor; battery; series resonant converter

Title

Found 10 Documents
Search

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Title Search

Found 10 Documents Search

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Title

Found 10 Documents
Search