Claim Missing Document
Check
Articles

Found 2 Documents
Search

Kendali Radio Repeater Komunikasi Dua Meter Band Menggunakan Sistem Telekontrol Dual Tone Multi-Frequency Aldi Rinaldi; Samuel Kristiyana; Wiwik Handajadi
Aviation Electronics, Information Technology, Telecommunications, Electricals, Controls (AVITEC) Vol 3, No 2 (2021): August
Publisher : Institut Teknologi Dirgantara Adisutjipto

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28989/avitec.v3i2.1043

Abstract

Repeater strongly supports the use of radio communication equipment for communication. The location of the repeater is usually at a high altitude so that the repeater's radio wave beam is not blocked by anything. The repeater arrangement is done by going directly to the repeater location so it is very inefficient from the time and accommodation factor. Therefore, a study was conducted to control the radio repeater settings remotely in order to reduce the accommodation of repeater control by visiting the radio repeater location. Control of radio repeater settings uses DTMF (Dual Tone Multi-Frequency) technology which sends DTMF signals and then converts them to binary data to be processed into data that is used for repeater control such as turning on and off the radio, setting high and low power, and adjusting channels on the repeater. the radio repeater. This system is also equipped with sending notifications in the form of SMS of the repeater operational conditions or settings. The research resulted in a remote control system based on DTMF technology equipped with a GSM/GPRS SIM800L module which is used to connect a smartphone to the system and send repeater operational notifications after controlling the repeater setting function. By using Telkomsel provider, the resulting delay when sending orders is 0.5 seconds and the delay in receiving SMS notifications is 12.96 seconds. Meanwhile, using Indosat provider, the resulting delay when sending commands is 0.43 seconds and the delay in receiving SMS notifications is 10.57 seconds.
Rancang Bangun Alat Ukur dan Pengendali Pemakaian Daya Listrik berbasis SMS Gateway Gatot Santoso; Wiwik Handajadi; Slamet Hani; Gani Halim Baskara
Prosiding Simposium Nasional Rekayasa Aplikasi Perancangan dan Industri 2019: Prosiding Simposium Nasional Rekayasa Aplikasi Perancangan dan Industri
Publisher : Universitas Muhammadiyah Surakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Pelanggan PT. PLN (Persero) selama ini mendapatkan layanan program listrik prabayar dan pascabayar, namun pada program listrik pascabayar sering terjadi human error pada saat petugas melakukan pembacaan meter. Program listrik pasca-bayar merupakan program bagi pelanggan untuk menggunakan energi listrik terlebih dahulu kemudian membayar pada bulan berikutnya. Setiap bulannya PT. PLN (Persero) harus mencatat meter, menghitung dan menterbitkan rekening yang harus di bayar oleh pelanggan dengan memasang sebuah alat ukur bernama kilo Watt Hours (kWh). Dengan menggunakan mikrokontroler Arduino Uno sebagai pengolah datanya, dan parameter yang diukur adalah arus dan tegangan menggunakan sensor arus ACS712-30A untuk mengukur arus yang mengalir dari sumber ke beban, sedangkan untuk mengukur tegangan menggunakan sensor ZMPT101B. Untuk mengirimkan data yang sudah diolah oleh Arduino Uno maka menggunakan SIM900 untuk mengirimkan jumlah pemakaian melalui SMS. Dari hasil pengujian tingkat presentase ketelitian dan ketepatan sensor arus ACS712-30A sebesar 87%, untuk ketelitian pada sensor tegangan ZMPT101B adalah 96,5%.. Sedangkan untuk pengiriman data menggunakan SIM900 error yang dihasilkan pada saat pengiriman data sebesar 100%.