Article Per Year (5 Year)
p-Index From 2021 - 2026
0
P-Index
This Author published in this journals
All Journal Jurnal Sains Materi Indonesia Jurnal Sains Materi Indonesia
Nurdin Effendi
Center for Technology of Nuclear Industry Materials (PTBIN) - BATAN Kawasan Puspiptek Serpong 15314, Tanggerang
Engineering Industrial & Manufacturing Engineering Materials Science & Nanotechnology

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
EFFECTS OF Ti ADDITION ON THE DIELECTRICAL PROPERTIES OF A NEW AUSTENITE ALLOY Aziz K. Jahja; Nurdin Effendi
Jurnal Sains Materi Indonesia Vol 9, No 2: FEBRUARI 2008
Publisher : Center for Science & Technology of Advanced Materials - National Nuclear Energy Agency

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (479.315 KB) | DOI: 10.17146/jsmi.2008.9.2.4735

Abstract

EFFECTS OF Ti ADDITION ON THE DIELECTRICAL PROPERTIES OF A NEW AUSTENITE ALLOY. Preparation of alloys has been carried out leading to a new type of austenite alloys designated A-1 with a composition of Fe 52.22 wt%, Ni 24.2 wt%, Cr 20.0 wt%, Si 1.0 wt%, Mn 2.0 wt%, C 0.08 wt% and Ti 0.5 wt%. The main difference compared to commercial alloys (e.g. A347) is that Ti is added as an alloying element, but no P and S. The frequency-dependent conductivity and dielectric response of this novel material have been investigated by RLC bridge impedance spectroscopy method. It was verified that the real dielectric constant κ' of these newA-1materials showawell defined dielectric behavior and shows a considerable improvement over the commercial A-347 alloywith similar composition. Both dielectric response and dielectric loss curves show frequency dispersive relaxation peaks, indicating different conduction process in the surface and in the bulk of the materials. Therefore the substitution of P and S with Ti resulting in a new austenite with different dielectric properties. These improved dielectric properties should make this new material a good candidate for use as electrical connector, but with a reduced corrosion, so the lifetime or duration of application could be extended.
EFFECTS OF Ti ADDITION ON THE DIELECTRICAL PROPERTIES OF A NEW AUSTENITE ALLOY Aziz K. Jahja; Nurdin Effendi
Jurnal Sains Materi Indonesia Vol. 9 No. 2 (2008): Jurnal Sains dan Materi Indonesia
Publisher : BRIN Publishing (Penerbit BRIN)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/jsmi.2008.9.2.4735

Abstract

Preparation of alloys has been carried out leading to a new type of austenite alloys designated A-1 with a composition of Fe 52.22 wt%, Ni 24.2 wt%, Cr 20.0 wt%, Si 1.0 wt%, Mn 2.0 wt%, C 0.08 wt% and Ti 0.5 wt%. The main difference compared to commercial alloys (e.g. A347) is that Ti is added as an alloying element, but no P and S. The frequency-dependent conductivity and dielectric response of this novel material have been investigated by RLC bridge impedance spectroscopy method. It was verified that the real dielectric constant κ' of these newA-1materials showawell defined dielectric behavior and shows a considerable improvement over the commercial A-347 alloywith similar composition. Both dielectric response and dielectric loss curves show frequency dispersive relaxation peaks, indicating different conduction process in the surface and in the bulk of the materials. Therefore the substitution of P and S with Ti resulting in a new austenite with different dielectric properties. These improved dielectric properties should make this new material a good candidate for use as electrical connector, but with a reduced corrosion, so the lifetime or duration of application could be extended.
Co-Authors Aziz K. Jahja