Article Per Year (5 Year)
p-Index From 2020 - 2025
0.23
P-Index
This Author published in this journals
All Journal Jurnal Sains Materi Indonesia
Iskandar Muda
University of Jenderal Achmad Yani, Bandung, Metallurgical Engineering Dept
Materials Science & Nanotechnology

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
EFFECT OF ANNEALING CYCLES ON DEEP DRAWABILITY OF LOW CARBON TITANIUM ADDED STEEL Iskandar Muda; Azwar Manaf
Jurnal Sains Materi Indonesia Vol 21, No 2: JANUARY 2020
Publisher : Center for Science & Technology of Advanced Materials - National Nuclear Energy Agency

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1161.481 KB) | DOI: 10.17146/jsmi.2020.21.2.5799

Abstract

EFFECT OF ANNEALING CYCLES ON DEEP DRAWABILITY OF LOW CARBON TITANIUM ADDED STEEL. Maximum mechanical properties and deep drawability of low carbon titanium added steels was obtained after heat treatment with simulation batch annealing cycles in an industrial process. The effect of holding times and holding temperatures on deep drawability were studied using tensile test for measuring normal anisotropy (r-value) and strain hardening exponent (n-value). Scanning electron microscope were employed for observation of microstructure in steel sheets. X-ray diffraction with pole figure techniques were also used for measuring texture of annealing. Results showed that as the temperature was increased up to 900 oC, both r and n values increased gradually and peaked in the temperature of 850 oC. This results showed that formability of sheet materials increased until batch annealing temperature reach 850 oC as increasing the ratio of intensities {111} /{100}. The largest mean r value of almost 2.6 was obtained in slow heating at holding temperature of 850 oC with n value of 0.27.
Co-Authors Azwar Manaf