Agus Jamaludin
Pusat Teknologi Bahan Bakar Nuklir – BATAN

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

ANALISIS KERUSAKAN X-RAY FLUORESENCE (XRF) Agus Jamaludin; Darma Adiantoro
PIN Pengelolaan Instalasi Nuklir No 9-10 (2012): April-Oktober 2012
Publisher : PIN Pengelolaan Instalasi Nuklir

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (541.653 KB)

Abstract

Analisis kerusakan alat XRF telah dilakukan. Kegiatan ini diperlukan sebagai langkah awal sebelum dilakukan langkah selanjutnya yaitu perbaikan alat. XRF merupakan alat yang terdapat di laboratorium Instalasi Radiometalurgi (IRM) yang digunakan untuk analisis unsur dalam bahan secara kualitatif maupun kuantitatif. Hasil analisis kualitatif adalah teridentifikasinya jenis-jenis unsur makro yang terkandung dalam suatu bahan berdasarkan energi sinar-x karakteristik yang dipancarkan oleh unsur dalam bahan tersebut. Sedangkan hasil analisis kuantitatif ditunjukkan oleh adanya spektrum unsur-unsur hasil pengukuran yang ditunjukkan dalam bentuk nilai cacah (counting). Nilai counting sangat menentukan nilai konsentrasi unsur yang terkandung dalam bahan yang dianalisis. Saat ini alat XRF sedang mengalami gangguan  pada sistem counting. Indikator kerusakan ditunjukkan oleh adanya ketidakstabilan nilai yang ditunjukkan oleh sistem counting tersebut. Oleh karena itu perlu dilakukan analisis kerusakan. Tahap analisis dilakukan pengecekan melalui pengamatan visual dan cara pengukuran langsung, Setelah dilakukan pengecekan secara visual maupun pengukuran langsung didapat kerusakan pada bagian window detektor, modul spinner dan modul display sample holder counter, dan detektor. Kerusakan modul spinner dan display disebabkan tetesan kondensasi dewar yang jatuh pada papan modul yang menyebabkan short circuit pada rangkaian.  Sedangkan kerusakan detektor disebabkan oleh adanya sensor nitrogen yang tidak berfungsi dengan baik. Kata Kunci : Analisis, Kerusakan, XRF
PENENTUAN RECOVERY NEODYMIUM DAN CERIUM PADA PROSES PEMISAHAN ISOTOP DARI SIMULASI PEB U3Si2/Al PRA IRADIASI Noviarty Noviarty; Erlina Noerpitasari; Rosika Kriswarini; Agus Jamaludin; Sutri Indaryati; Sayyidatun Nisa; Samsul Fatimah
Urania: Jurnal Ilmiah Daur Bahan Bakar Nuklir Vol. 26 No. 1 (2020): Urania : Jurnal Ilmiah Daur Bahan Bakar Nuklir
Publisher : Badan Riset dan Inovasi Nasional

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/urania.2020.26.1.5791

Abstract

DETERMINATION OF NEODYMIUM AND CERIUM RECOVERY IN ISOTOPE SEPARATION PROCESS OF SIMULATED PRE-IRADIATED U3Si2/Al FUEL. Neodymium (Nd) is one of the fission product isotopes used as an indicator of nuclear fuel burn-up because Nd isotope is a stable fission product, has a sufficiently great yield, is not volatile and has low neutron-capture cross- section. Burn-up determination using Nd can support and verify the results of the burn-up determined by using Cs, U and Pu isotopes. Destructive burn-up determination (Destructive Test, DT) is based on the determination of specific isotopes that is performed physicochemically using mass spectrometer equipment. Based on ASTM E 321-69 method for Nd isotope analysis, Nd separation from Ce is required because 142Ce isotope interferes with 142Nd measurement due to their being isobars, and this phenomenon will affect the results of the burn-up calculations. In addition, Nd isotope in U3Si2/Al fuel is present along with other fission isotopes such as 235U, 239Pu, 148Nd, 137Cs, 152Eu, 90Sr, 143Ce, 103Ru, 95Zr, and 95Nb. Therefore, to obtain an accurate value to be used as burn-up indicator, the isotopes must be separated. Before the Nd and Ce separation, several separation phases of Cs isotopes (137Cs, 134Cs), U isotopes (234U, 235U, 236U, 238U), Pu isotopes (239Pu, 238Pu) and other isotopes (152Eu, 90Sr, 103Ru, 95Zr and 95Nb) were done. The determination of separation recovery aimed to determine the amount of Nd and Ce at each stage of the separation process of other isotopes prior to the separation stage of Nd and Ce. The determination of recovery was conducted by a simulation of fresh U3Si2/Al solution plus standard solutions of Cs, U, Nd and Ce. The recovery for Nd and Ce from Cs separation phase using zeolites were 69.91% and 64.42% respectively while the recovery of Nd and Ce at Pu and U separation phase were close to 100%. The recovery values of Nd and Ce were then used as a correction in the calculation of Nd and Ce separation from the fuel solution, and the corrected values can then be used as a reference in determining the burn-up of U3Si2/Al fuel using Nd as an indicator.