Emiliana Kasmudjiastuti
BBKKP

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Spektroscopi FTIR dan sifat mekanik nanokomposit grafting HDPE dan nanoprecipitated calcium carbonate (NPCC) Arum Yuniari; Emiliana Kasmudjiastuti
Majalah Kulit, Karet, dan Plastik Vol 28, No 2 (2012): Majalah Kulit, Karet, dan Plastik
Publisher : Center for Leather, Rubber, and Plastic Ministry of Industry, Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1037.026 KB) | DOI: 10.20543/mkkp.v28i2.110

Abstract

ABSTRACTThe purpose of this research based on high density polyethylene (HDPE) and nanoprecipitated calciumcarbonate (NPCC) was to evaluate the effect of nanoprecipitated calcium carbonate (NPCC) on FTIR spectroscopy and mechanical properties. The nanocomposites was prepared with a rheomix 3000 Haake at 180 º C and 50 rpm of rotor speed for 10 minutes. The composition of HDPE and additives were permanently, and NPCC content varied 10, 15, 20, 30, 40 and 50 phr (per hundred resin) respectively and control was made inherent NPCC. The nanocomposites were characterized using tensile strength, hardness tester, electro densimeter and Fourier Transform Infra Red (FTIR) spectroscopy techniques. The results of mechanical properties showed that the increasing the amount of NPCC was able increase hardness and density while elongation at break more stable and tensile strength decreased. Analysis functional group on nanocomposites with Fourier Transform Infra Red (FTIR) indicated a new peak on wave band 3472,49 cm-1 (OH stretching).ABSTRAKPenelitian tentang pembuatan nanokomposit dari bahan high density polyethylene(HDPE) dan nanoprecipitated calciumcarbonate (NPCC) bertujuan untuk mengetahui pengaruh penambahan filler NPCC terhadap sifat mekanik dan spektroscopi. Nanokomposit dibuat dengan Rheomix 3000 Haake pada suhu 180oC dan kecepatan 50 rpm selama 10 menit. Komposisi HDPE dan bahan aditif dibuat tetap, dan kandungan NPCC divariasi berturut-turut 10 ; 20 ; 30; 40 dan 50 phr (per hundred resin) dan dibuat kontrol tanpa ditambah NPCC. Sifat mekanik diuji dengan alat ujitensile strength, hardness, densimeter dan karakterisasi gugus fungsi ditentukan menggunakan Fourier Transform Infra Red (FTIR). Hasil uji sifat mekanik menunjukkan semakin tinggi jumlah NPCC kekerasan dan densitas naik, kemuluran tetap sedangkan kuat tarik cenderung turun. Spektrum nanokomposit HDPE/NPCC menunjukkan terjadinya puncak baru pada bilangan gelombang 3472,49 cm-1 (OH stretching).
Pengaruh jumlah minyak terhadap sifat fisis kulit ikan nila (Oreochromis niloticus) untuk bagian atas sepatu Iwan Fajar Pahlawan; Emiliana Kasmudjiastuti
Majalah Kulit, Karet, dan Plastik Vol 28, No 2 (2012): Majalah Kulit, Karet, dan Plastik
Publisher : Center for Leather, Rubber, and Plastic Ministry of Industry, Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (627.423 KB) | DOI: 10.20543/mkkp.v28i2.113

Abstract

ABSTRACTFatliquor could change physical properties of leather, which make it softer, more elastic, flexible and give smooth grain surface. This research was conducted to observe the influence of fatliquor addition on physical characteristics of nila skin for shoe upper. The physical characteristics in this research, consisted of tensile strength, tear strength and elongation at break. The fatliquor was put into the leather with the amount of 4%, 6% and 8%. Respectively, the results showed that the addition of fatliquor could improve the physical properties of nila skin. More fatliquor, could rise the physical properties value of nila skin. The optimal amount of fatliquor was 4%, which resulted in tensile strength value of 233,96 kg/cm2, 70% for elongation at break and 36,08 kg/cm for tear strength value, and fulfill the standard requirement of Acceptable Quality Levels in Leathers.ABSTRAKMinyak/lemak merupakan komponen penting dalam kulit yang berfungsi untuk melunakkan kulit atau sebagai pelumas jaringan kulit pada proses penyamakan kulit. Minyak atau lemak dapat mengubah sifat-sifat penting kulit antara lain kulit menjadi lebih lunak, liat, mulur, lembut, dan permukaan rajahnya lebih halus. Tujuan penelitian ini untuk mempelajari pengaruh penambahan jumlah minyak sulfonasi terhadap kualitas fisik kulit ikan nila untuk bagian atas sepatu. Sifat fisik yang diamati meliputi kekuatan tarik, kekuatan sobek dan kemuluran. Dalam penelitian ini variasi jumlah minyak yang digunakan adalah 4, 6 dan 8%. Hasil penelitian menunjukkan bahwa semakin banyak penambahan minyak, dapat meningkatkan sifat fisis dari kulit ikan nila. Penambahan minyak yang optimal adalah sebesar 4%, yang menunjukkan sifat fisis dengan nilai kekuatan tarik 233,96 kg/cm2, kemuluran 70% dan kekuatan sobek 36,08 kg/cm, dan memenuhi persyaratan yang ditetapkan dalam Acceptable Quality Levels in Leathers.