Article Per Year (5 Year)
p-Index From 2020 - 2025
0.408
P-Index
This Author published in this journals
All Journal Jurnal Teknik Mesin Jurnal Teknik Mesin
Yanto Darman
Institut Teknologi Padang
Control & Systems Engineering Energy Industrial & Manufacturing Engineering Materials Science & Nanotechnology Mechanical Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
The Influence of the Initial Angle of the Cut and the Depth of Cut on the Shaping Process to Edge Wear of HSS Chisel Anrinal Anrinal; Asmara Yanto; Hendriwan Fahmi; Yanto Darman
Jurnal Teknik Mesin (JTM) Vol 10, No 2 (2020)
Publisher : LP2M - Institut Teknologi Padang

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

The purpose of this research is to provide an overview of the effect of the initial angle of cut and depth of cut on the edge wear of the HSS chisel in the wear resistant steel cutting process using a scrap machine. This research was conducted using the KLOPP brand scrap machine, Type 550, Machine Code SC 01, Cutting speed (V) 15 m / min, Feeding motion (f) 0.4 mm / step, cutting time 5 minutes, using HSS Bohler scrap chisel Rapid Extra 1200 (3/8 "X 4") with variations in the initial angle of cutting (λ) 50 , 150, 250 and variations in the depth of cut (a) 0.4 mm, 0.8 mm and 1.2 mm. The results showed that an increase in the initial angle of cut and depth of cut tended to result in an increase in the edge wear of the HSS chisel.
The Influence of the Initial Angle of the Cut and the Depth of Cut on the Shaping Process to Edge Wear of HSS Chisel Anrinal; Asmara Yanto; Hendriwan Fahmi; Yanto Darman
Jurnal Teknik Mesin Vol 10 No 2 (2020): Jurnal Teknik Mesin Vol.10 No.2 October 2020
Publisher : Lembaga Penelitian dan Pengabdian Masyarakat (LP2M) - ITP

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1178.939 KB) | DOI: 10.21063/jtm.2020.v10.i2.88-96

Abstract

The purpose of this research is to provide an overview of the effect of the initial angle of cut and depth of cut on the edge wear of the HSS chisel in the wear resistant steel cutting process using a scrap machine. This research was conducted using the KLOPP brand scrap machine, Type 550, Machine Code SC 01, Cutting speed (V) 15 m / min, Feeding motion (f) 0.4 mm / step, cutting time 5 minutes, using HSS Bohler scrap chisel Rapid Extra 1200 (3/8 "X 4") with variations in the initial angle of cutting (λ) 50 , 150, 250 and variations in the depth of cut (a) 0.4 mm, 0.8 mm and 1.2 mm. The results showed that an increase in the initial angle of cut and depth of cut tended to result in an increase in the edge wear of the HSS chisel.
Co-Authors Anrinal Anrinal Asmara Yanto Hendriwan Fahmi