Article Per Year (5 Year)
p-Index From 2020 - 2025
0.23
P-Index
This Author published in this journals
All Journal Infotekmesin
Trio Nur Wibowo
Sekolah Tinggi Teknik Wiworotomo
Computer Science & IT Electrical & Electronics Engineering Mechanical Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Optimasi Parameter Gravitasi Shot Peening Terhadap Kekasaran, Kekerasan dan Struktur Mikro ST 45 dengan Metode Taguchi Trio Nur Wibowo; Hartono Hartono; Bambang Sugiantoro
Infotekmesin Vol 12 No 1 (2021): Infotekmesin: Januari 2021
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v12i1.519

Abstract

Shot peening is a surface treatment method at low temperature by shooting steel balls that are continuously adjusted for pressure and speed until plastic deformation is produced. The optimal parameter of the shot peening process was tested with the taguchi distribution. The factors and levels used are processing time, shooting distance and air pressure used in the shot peening process. Observations were made by looking at changes in surface roughness, thickness reduction, hardness levels, wear and changes in the microstructure of ST 45 steel material. The greatest hardness of 240.39 HVN was obtained at 10 minutes, a distance of 10 cm and a pressure of 9 kg / cm². The results of the surface wear test with the smallest value of 0.00039 mm³ / kg.m were obtained at 5 minutes, a distance of 10 cm and a pressure of 7 kg / cm². The results of the microstructure test showed that the change in the grain size of the microstructure of the material became flatter and smaller, the gravity shot peening method improved the mechanical properties of the ST 45 material.
Co-Authors Bambang Sugiantoro Hartono Hartono