Garuda - Garba Rujukan Digital

p-Index From 2021 - 2026

P-Index

This Author published in this journals

All Journal Indonesian Mining Journal Indonesian Mining Journal

SLAMET SUPRAPTO

R & D Centre for Mineral and Coal Technology

Author-ID : 3949918

Chemical Engineering, Chemistry & Bioengineering Chemistry Earth & Planetary Sciences Energy Engineering Environmental Science Materials Science & Nanotechnology

Published : 4 Documents Claim Missing Document

Claim Missing Document

Articles

Title

PRODUCTION OF SYNTHESIS GAS FROM INDONESIAN LOW RANK COALS USING FLUIDIZED BED GASIFICATION REACTOR SLAMET SUPRAPTO; NURHADI NURHADI
Indonesian Mining Journal Vol 10, No 2 (2007): INDONESIAN MINING JOURNAL Vol. 10 No. 2 June 2007
Publisher : Puslitbang tekMIRA

In relation to the objective of securing energy and raw material supplies for industries and increasing of low rank coal utilization; research on the production of synthesis gas from Indonesian coal has been carried out. Low rank coal samples and a fluidized bed reactor which was equipped with gas purification system have been used. The coal samples used were Adaro coal (sub bituminous), Mulia and Gunung Bayan (lignitic coals). Gasifying agent was also varied and consisted of oxygen, oxygen/ steam mixture and steam. Stoichiometric ratio of oxygen/carbon was kept at one half and oxygen/ steam ratio was one. The gasification temperature was kept constant at 900ºC. The composition of gas products were analyzed using a gas chromatograph with molsieve and porapak columns. The results showed that there was a good correlation between gasifying agent, coal used, quality and quantity of synthesis gas.

PRODUCTION OF ACTIVATED CARBON FROM SUBBITUMINOUS COAL USING ROTARY KILN AND CYCLONE BURNER IKA MONIKA; SLAMET SUPRAPTO
Indonesian Mining Journal Vol 14, No 1 (2011): INDONESIAN MINING JOURNAL Vol. 14 No. 1 February 2011
Publisher : Puslitbang tekMIRA

Research on the production of activated carbon from coal has been carried out by Research and Develop- ment Center for Mineral and Coal Technology since 1980 in the laboratory as well as pilot plant scale. Production of activated carbon from coal using rotary kiln and oil burner at the pilot plant of 1 ton/day has been carried out successfully to produce good quality product. To reduce the dependence upon using oil fuel, the oil fuel burner was replaced by coal fueled cyclone burner. Product quality and economic evalua- tion of the production of activated carbon using the burners are described in this paper. The coal used was subbituminous coal from Air Laya, South Sumatera. The coal passing 3 cm screen was carbonized at 500- 600° C for 2 hours to produce good quality char. The variables of activation process observed were con- sisted of particle size of char (+6, -6+12 and -12 +20 mesh) and residence time (1.5, 3 and 6 hours). The results showed that the optimum condition for activation process was using particle size of -6+12 mesh and residence time at a minimum of 3 hours. The activated carbon produced showed quality which fairly met the requirement of Indonesian Industrial Standard with iodine number of 600-800 mg/g compared with stan- dard of 750-1200 mg/g and market quality of 400-1200 mg/g. Eventhough the adsorption capacity obtained was at the lowest limit of the Indonesian Industrial Standard, however the pre utilization test showed that the product could be used for treatment of shrimp farms water.

Co-Authors Ika Monika NURHADI NURHADI

Title Search

Found 2 Documents Search Journal : Indonesian Mining Journal

Abstract

Abstract

Title

Found 2 Documents
Search
Journal : Indonesian Mining Journal