Chaidir Anwar Makarim
Unknown Affiliation

Published : 5 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 5 Documents
Search

STUDI PERBANDIGAN TEKANAN LATERAL TANAH SEDANG DAN TANAH AMAT LUNAK Alexandro Kevin Wijaya; Chaidir Anwar Makarim
JMTS: Jurnal Mitra Teknik Sipil Volume 5, Nomor 2, Mei 2022
Publisher : Prodi Sarjana Teknik Sipil, FT, Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmts.v5i2.16746

Abstract

Indonesia is a country consisting of thousands of islands and different geographical conditions. Soil conditions in Indonesia have different characteristics. Soil is made up of minerals and organic materials. The distribution of very soft soil in Indonesia is quite large, but it is rarely discussed and even questioned, so that it can cause construction failure. It turns out that the nature of the very soft soil is different from the nature of the soil in general. Very soft soil has soil properties that tend to be like 'thick water' like slurry that flows freely compared to soil in general. In this study, an analysis of the comparison of the lateral pressure of the soil on medium and very soft soils will be carried out, without paying attention to external loads. This is done by comparing the lateral pressure of the soil when the soil is at rest, the active and passive states when the soil is moderate and the soil is very soft for each soil layer. The analysis of the results of mathematical calculations is entered into a geotechnical-based program for lateral soil deformation. The results of the analysis of the calculation of the lateral stress and pressure of the soil, it was found that the lateral pressure of the soil in the very soft soil is greater than the stress and the lethal pressure of the soil in the medium soil, and the resulting deformation of the very soft soil layer is greater than the result of the medium soil layer. Indonesia merupakan negara yang terdiri dari beribu-ribu pulau dan kondisi geografis yang berbeda-beda pula. Kondisi tanah di Indonesia memiliki karakteristik yang berbeda-beda. Tanah sendiri terbentuk dari mineral dan bahan-bahan organik. Sebaran tanah amat lunak di Indonesia lumayan banyak namun jarang dibahas bahkan dipermasalahkan, sehingga dapat menyebabkan kegagalan konstruksi. Ternyata sifat dari tanah amat lunak berbeda dengan sifat dari tanah pada umumnya. Tanah amat lunak memiliki sifat tanah yang cenderung seperti ‘air kental’ bagaikan bubur yang mengalir dengan bebas dibandingkan dengan tanah pada umunya. Pada peneilitian akan dilakukannya analisis perbandingan tekanan lateral tanah terhadap tanah sedang dan tanah amat lunak, dengan tidak memperhatikan beban yang berasal dari luar. Dilakukan dengan membandingakan tekanan lateral tanah pada saat tanah keadaan diam, keadaan aktif maupun pasif pada saat keadaan tanah sedang dan tanah amat lunak untuk setiap lapisan tanah. Analisis dari hasil perhitungan matematis dimasukan kedalam program berbasis geoteknik untuk defromasi lateral tanah. Hasil dari analaisi perhitungan tegangan dan tekanan lateral tanah didapakatkan tekanan lateral tanah pada keadaan tanah amat lunak lebih besar dibandingkan dengan tegangan maupaun tekanan leteral tanah pada keadaan tanah sedang, dan deformansi yang dihasilkan dari lapisan tanah amat lunak lebih besar dibandingan hasil dari lapisan tanah sedang.
ANALISIS TIANG PANCANG SEBAGAI DINDING PENAHAN TANAH DENGAN MENGGUNAKAN PROGRAM METODE ELEMEN HINGGA Hans Wilsen Cahyadinata; Chaidir Anwar Makarim
JMTS: Jurnal Mitra Teknik Sipil Volume 3, Nomor 3, Agustus 2020
Publisher : Prodi Sarjana Teknik Sipil, FT, Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmts.v3i3.8373

Abstract

In recent years the number of  infrastructure construction in Indonesia is surging. Sometimes soil excavation and filling at the construction site needed to be done. Disturbtion of soil may cause soil instability at the site so in order to prevent it from collapsing constructing a retaining wall is one  possible solution like constructing a retaining wall from concrete piles on river flow area to replace the old soil retaining wall that broke down. Rainfall is simulated by staging the rise of both groundwater and river surface level. The concrete piles used have dimension of 400x400 mm and 0,8 m between each pile and topped of with capping beam 0,8 m wide and 0,5 m thick. Calculation is done by program for deflection and moment of pile with Mohr-Coulomb model. Deflection and moment of pile when groundwater level is at -6 meter is 2,376 cm and 115,40 kNm, then 4,245 cm and 199,95 kNm when groundwater level reaches ±0 meter. The results will then be compared  agaisnt maximum deflection and moment allowed for the pile. After analysis is done it is found that both deflection and moment experienced a greater jump in value when groundwater level is nearing top of pile. AbstrakBeberapa tahun belakangan banyak pembangunan yang berjalan di Indonesia. Namun terkadang kontur tanah pada lokasi pembangunan kurang sesuai dengan kebutuhan desain sehingga dilakukan penggalian atau pengurugan. Pengubahan kontur tanah dapat menyebabkan ketidakstabilan pada tanah di lokasi sehingga salah satu solusi untuk mencegah terjadinya longsor pada tanah adalah dengan membuat dinding penahan tanah. Salah satu hal yang menarik adalah pembangunan dinding penahan tanah dari tiang pancang beton di daerah aliran sungai untuk menggantikan dinding penahan tanah lama yang rusak. Perhitungan akan mensimulasikan terjadinya hujan sehingga terjadi peningkatan muka air tanah dan permukaan sungai secara bertahap. Tiang yang digunakan pada pemodelan memiliki ukuran 400x400 mm dengan jarak antar tiang 0,8 meter yang dihubungkan oleh capping beam selebar 0,8 meter dan tebal 0,5 meter. Perhitungan dilakukan dengan program untuk mencari defleksi dan momen pada tiang pada pemodelan Mohr-Coulomb. Defleksi dan momen yang terjadi pada tiang saat muka air tanah -6 meter sebesar 2,376 cm dan 115,40 kNm, kemudian saat ±0 meter sebesar 4,245 cm dan 199,95 kNm. Hasil defleksi dan momen kemudian dibandingkan terhadap syarat batas yang sudah ditentukan sebelumnya. Setelah analisis dilakukan ditemukan bahwa kenaikan defleksi dan momen paling besar terjadi pada tahap dimana air naik mendekati puncak tiang.
ANALISIS TIANG PANCANG SEBAGAI DINDING PENAHAN TANAH DI DAERAH ALIRAN SUNGAI MENGGUNAKAN PROGRAM PYWALL Amelinda Jocelin; Chaidir Anwar Makarim
JMTS: Jurnal Mitra Teknik Sipil Volume 3, Nomor 3, Agustus 2020
Publisher : Prodi Sarjana Teknik Sipil, FT, Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmts.v3i3.8375

Abstract

Construction failure may occur due to various things. One of them is used a shallow foundation for a retaining wall. It can possible, but consider environmental condition where there is a heavy flow of water along the wall. Therefore it is necessary to use a deep foundation. Pile are printed concrete products. It is used to support a load and distribute the load to the subgrade. This pile is also equipped with iron reinforcement so that it can guarantee the quality and strength. This calculation is using a closed-form solution. The software used is P-Y Wall which fixes a flexible retaining wall or pile/drill wall. This program will calculate pile deflection, shear forces, and bending moments. In this assessment, variations were made relating to the distance between the piles and the values of L1 and L2. L1 shows the free long pile and L2 shows the long pile entering the ground. Variation 3A with the distance between the piles 100 cm and the length of the pile 15 m. The average value of L1 was 10.8 m for the value and the value of L2 was 4.2 m. Both of deflection and moment can fulfill the qualification, the value is 9,1 m (from 10,8 m) dan 320 kNm (from 399 kN/m).
PROSES ANALISA DINDING GALIAN BASEMENT 7 LANTAI DENGAN METODE ELEMEN HINGGA Novia Sabina; Chaidir Anwar Makarim
JMTS: Jurnal Mitra Teknik Sipil Volume 3, Nomor 1, Februari 2020
Publisher : Prodi Sarjana Teknik Sipil, FT, Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmts.v3i1.6980

Abstract

Limited area for construction can be overcome by build a multi-story building with basement. Basement is quite common in Jakarta, the things that attracted is basement with 7 stories. This basement construction use a diaphragm wall with 1 meter thickness for the retaining wall and installation strut every 4 meter. Deformation for diaphragm wall is calculated by finite element method application and mohr-coloumb soil modeling. This calculation based on soil type from each drill point and water table when it high or common. From the calculation, maximum deformation diaphragm wall for BH-5 when water table high is 235,86 mm and when water table at -3 m is 209,6 mm. Maximum deformation diaphragm wall for BH-7 when water table high is213,9 mm and when water table at -3 m is 197,18 mm. There are several things that need to concern when constructed basement and deep excavation, in case to avoid failure.AbstrakKeterbatasan lahan untuk pembangunan dapat diatasi dengan pembangunan gedung bertingkat yang dilengkapi dengan basement. Pembangunan basement cukup umum di Jakarta ini, salah satu hal yang menarik perhatian adalah pembangunan basement sebanyak 7 lantai. Pembangunan basement ini menggunakan dinding penahan tanah berupa dinding diafragma dengan ketebalan 1 meter dan pemasangan strut setiap 4 meter. Perhitungan deformasi pada dinding penahan tanah ini dilakukan dengan menggunakan aplikasi metode elemen hingga dan permodelan tanah mohr-coloumb Permodelan dilakukan berdasarkan keadaan tanah pada tiap titik bor dan keadaan muka air saat banjir atau kemarau. Dari perhitungan, didapatkan deformasi maksimum dinding diafragma pada titik bor BH-5 pada muka air banjir adalah 235,86 mm dan pada muka air kemarau adalah 209,6 mm. Untuk deformasi maksimum dinding diafragma pada titik bor BH-7 pada muka air banjir adalah 213,9 mm dan pada muka air kemarau adalah 197,18 mm. Pada saat konstruksi basement dan galian dalam, diperlukan beberapa hal yang perlu diperhatikan agar tidak terjadi kegagalan pada saat pembangunan dan penggunaan basement.
ANALISIS EFEKTIVITAS PENGGUNAAN MICROPILE SEBAGAI ELEMEN PERKUATAN STABILITAS LERENG Farrell Arman; Chaidir Anwar Makarim
JMTS: Jurnal Mitra Teknik Sipil Volume 3, Nomor 1, Februari 2020
Publisher : Prodi Sarjana Teknik Sipil, FT, Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmts.v3i1.6987

Abstract

Landslide is one of the most common problems in the geotechnical field, especially in Indonesia. Landslide can occur due to increased shear stress of a soil mass or decreased shear strength of a soil mass that can happen overtime or in an instant. In other words, the shear strength of a soil mass is not able to withstand the load of the soil mass on top of it because the soil is unstable. To solve the problem of landslides, a proper and effective reinforcement is needed. Micropile is one of the ways that can be used as slope reinforcement, it can retain the soil mass on a higher location so the slope won’t collapse on its own. Micropile can be used as a retaining wall, it is quite easy to be applied on the field, it has a small diameter, and a relatively low cost. The compressive strength of the micropile is used to withstand the soil mass on a higher location. In this analysis, the carrying capacity of the micropile will be analyzed by manual calculation. The carrying capacity of the micropile will then be reanalyzed with the help of the limit equilibrium method software. The result at the end of this process is the safety factor of the simulated slope. This analysis is done twice, one is the simulation of a slope that is reinforced by micropile, and the other is not reinforced with micropile. The final result of both calculations will be compared to one another. This analysis will then result in the effectiveness of micropile as an element to maintain slope stability.AbstrakKelongsoran tanah pada lereng merupakan salah satu permasalahan yang paling sering terjadi di dalam dunia geoteknik, terutama di Indonesia. Kelongsorsan dapat terjadi akibat meningkatnya tegangan geser suatu massa tanah atau menurunnya kekuatan geser suatu massa tanah. Dengan kata lain, kekuatan geser dari suatu massa tanah tidak mampu memikul beban yang terdapat di atasnya karena kondisi tanah tidak stabil. Untuk mengatasi masalah kelongsoran pada lereng, diperlukan perkuatan yang tepat dan efektif. Micropile merupakan salah satu jenis perkuatan yang dapat membantu menahan massa tanah di lokasi yang lebih tinggi pada suatu lereng, karena micropile dapat dimanfaatkan sebagai dinding penahan tanah, mudah diaplikasikan, memiliki ukuran yang kecil, dan biaya yang relatif murah. Kapasitas micropile yang berguna untuk menahan massa tanah di lokasi yang lebih tinggi adalah kapasitas micropile untuk menahan tekan. Pada analisis ini, perhitungan kapasitas micropile akan dianalisa dengan perhitungan manual. Nilai kapasitas micropile kemudian akan diolah kembali dengan bantuan program metode kesetimbangan batas, sehingga didapatkan nilai faktor keamanan dari lereng yang telah didesain. Hasil pengolahan data dari analisis stabilitas lereng dengan micropile ini nantinya akan dibandingkan dengan hasil pengolahan data dari analisis stabilitas lereng tanpa micropile. Analisis ini akan menghasilkan efektivitas micropile sebagai elemen perkuatan stabilitas lereng.