Article Per Year (5 Year)
p-Index From 2020 - 2025
0.23
P-Index
This Author published in this journals
All Journal Journal of Engineering and Technological Sciences
Ahmad Rendi Maulana
Department of Mechanical Engineering, Faculty of Engineering, Universitas Jember, Jalan Kalimantan No. 37, Jember 68121, Indonesia
Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Effect of Temperature, Holding Time, and Addition of Sn on Density on Metal Injection Molding Sintering Process Wardatul Jannah; Danang Yudistiro; Mochamad Asrofi; Mahros Darsin; Ahmad Rendi Maulana
Journal of Engineering and Technological Sciences Vol. 55 No. 2 (2023)
Publisher : Directorate for Research and Community Services, Institut Teknologi Bandung

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.5614/j.eng.technol.sci.2023.55.2.4

Abstract

Metal injection molding (MIM) is a metal forming technique that combines powder metallurgy with plastic injection molding. MIM is very efficient in manufacturing small and complex products in large quantities. The MIM process has four steps: mixing, debinding, injection molding, and sintering. This research was conducted to determine the effect of variations in Sn addition, temperature, and holding time on the density of Al-PP products after the sintering process. Density is mass per volume so to find out the volume of Al-PP products, the use of a 3D scanner was attempted along with the EinScan application and a mesh mixer. The Taguchi method was used for data processing to determine the influence of variations in Sn addition, temperature, and holding time on density. The calculation of the percentage contribution showed that variations in Sn addition, temperature, and holding time affected density by 47%, 21%, and 3%. Also, 2% Sn addition yielded a reasonably good microstructure formation compared to without Sn addition and 1% Sn addition, where many voids remained in the specimen (the more significant the voids, the lower the density).
Co-Authors Danang Yudistiro Mahros Darsin Mochamad Asrofi Wardatul Jannah