Claim Missing Document
Check
Articles

Found 2 Documents
Search

Characteristics of Marshall Asbuton (Ac-Wc) Premixed with Asphalt Pen 60/70 (AC-WC) on the Duri – Kandis Road Preservation Project - Sp. Palas - Siak II (Pekanbaru) Mhd Islah; Hanantatur Adeswastoto; Resy Kumala Sari
Journal of Engineering Science and Technology Management (JES-TM) Vol. 3 No. 2 (2023): September-February 2023
Publisher : Journal of Engineering Science and Technology Management

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31004/jestm.v3i2.130

Abstract

The development of development in the industrial world does not escape the use of building materials, one of which is asphalt, which is often used in road construction. Asbuton is one of Indonesia's natural resources whose quality cannot be doubted. One of the asbuton technologies that is widely used is pre-mixed asbuton. Pre-mixed asphalt is one type of modified asphalt used in Indonesia. Pre-mixed Asbuton is processed and mixed with Asphalt Pen 60/70 in a factory that meets certain requirements, so it is equivalent to Modified Asphalt. This research aims to obtain a comparison of the characteristic values of Premixed Asbuton (AC-WC) with Pen 60/70 Oil Asphalt (AC-WC). The method used is experimental by carrying out laboratory tests. The test results for Premixed Asbuton (AC-WC) stability were 1,239.2 and Flow 3.82. Meanwhile, Asphalt Pen 60/70 (AC-WC) Stability is 1,051.4 and Flow 3.17
Objective Matrix (OMAX) Analysis to Determine Production Productivity Yulia Indriani; Resy Kumala Sari; Safni Marwa
Journal of Engineering Science and Technology Management (JES-TM) Vol. 4 No. 1 (2024): March-August 2024
Publisher : Journal of Engineering Science and Technology Management

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31004/jestm.v4i1.150

Abstract

PT. Mitra Bumi is a company operating in the palm oil sector that produces CPO and so far wants to know the level of productivity. OMAX is a partial productivity measurement system developed to monitor productivity in each part of the company with productivity criteria that are appropriate to the existence of that part (objective). Productivity is an important factor to support the survival of a company by analyzing and evaluating the output obtained based on its level of performance during a certain period. To find out the current level of productivity in the production department, it is necessary to measure productivity, because the results of this productivity measurement can be used as a consideration for implementing efforts that can be made to increase the company's productivity. Productivity measurements at PT Mitra Bumi are carried out using the method, objective matrix analysis (OMAX). The criteria used in this research are raw material productivity, effective working hours productivity, machine working hours and production effectiveness. The highest productivity index value was in July with a total value of 112.00%, while the lowest value was in June with a value of -91.33%. The cause and effect diagram is used to determine the causes of the decline in productivity in the CPO production section. As a result, production productivity at PT Mitra Bumi was influenced by factors that caused productivity to decrease, namely damage to the tippler machine, unsuitable raw materials, and less skilled operators