Welding is the most dominant joining technique used; the strength of a welded joint is determined not only by the type of material but also by how well the filler metal penetrates the joint gap. ST 40 steel is a material with good weldability. However, in critical structural applications, the strength of a welded joint depends not just on the base material, but on the extent to which the filler metal penetrates the joint gap. By comparing the mechanical properties of V-groove and U-groove welds, the goal is to identify the joint configuration that provides maximum strength with a low risk of failure. Tensile testing results show a tensile strength of 292.8 MPa for the U-groove weld and 322.56 MPa for the V-groove weld. Strain values were 12.66% for the U-groove and 9.86% for the V-groove. Yield strength values were 222.96 MPa for the V-groove and 211.44 MPa for the U-groove. Finally, the modulus of elasticity—determined via tensile testing—was 3,271.40 MPa for the V-groove weld and 2,312.80 MPa for the U-groove weld.
Copyrights © 2026