This article aims to analyze the axial and lateral bearing capacity of a single bored pile (100 cm in diameter, 25 m long) in Medan based on Standard Penetration Test (N-SPT) data. The problem is focused on the ability of the pile to carry combined vertical load, shear, and moment without geotechnical failure or excessive deformation. To approach this problem, axial pile capacity theory (skin friction and end bearing) and a lateral analysis based on p-y curves were applied using AllPile 7 software. The data were collected from N-SPT tests at eight soil depths (0 to 25 m) and loading data (Q = 1195.2 kN; P = 24.7 kN; M = 19.4 kN-m), and were analyzed quantitatively through vertical and lateral analyses. The results show an ultimate axial capacity of 9034.702 kN, an allowable capacity of 4517.351 kN, and a settlement of only 0.135 cm under the working load, while the lateral pile-head deflection is 0.410 cm with a maximum moment of 118.00 kN-m, well below the allowable deflection of 2.54 cm. This study concludes that the planned bored pile is safe for both axial and lateral loads, with a ratio of allowable capacity to working load (Qallow/Q) of about 3.8. A manual verification using the Reese and O'Neill method gives an ultimate capacity of 5133.9 kN (about 57% of the AllPile result) and an allowable capacity of 2566.9 kN, which still exceeds the working load, while a P–M interaction check shows that the 20D16 reinforcement can resist the maximum moment from the lateral analysis.
Copyrights © 2026